English
Language : 

Z1SMA1_14 Datasheet, PDF (1/3 Pages) Diotec Semiconductor – Surface mount Silicon-Zener Diodes (
Z1SMA1 ... Z1SMA100 (1 W)
Z1SMA1 ... Z1SMA100 (1 W)
Surface mount Silicon-Zener Diodes (non-planar technology)
Flächendiffundierte Si-Zener-Dioden für die Oberflächenmontage
Version 2014-07-11
5± 0.2
Maximum power dissipation
Maximale Verlustleistung
Nominal Z-voltage – Nominale Z-Spannung
1± 0.3
Type
Typ
0.15
Plastic case
Kunststoffgehäuse
Weight approx. – Gewicht ca.
Plastic material has UL classification 94V-0
Gehäusematerial UL94V-0 klassifiziert
4.5± 0.3
Dimensions - Maße [mm]
Standard packaging taped and reeled
Standard Lieferform gegurtet auf Rolle
1W
1 ... 100 V
~ SMA
~ DO-214AC
0.07 g
Standard Zener voltage tolerance is graded to the international E 24 (~5%) standard.
Other voltage tolerances and higher Zener voltages on request.
Die Toleranz der Zener-Spannung ist in der Standard-Ausführung gestuft nach der internationalen
Reihe E 24 (~5%). Andere Toleranzen oder höhere Arbeitsspannungen auf Anfrage.
Maximum ratings and Characteristics
Grenz- und Kennwerte
Power dissipation
Verlustleistung
TA = 50°C
Ptot
1 W 1)
Operating junction temperature – Sperrschichttemperatur
Storage temperature – Lagerungstemperatur
Tj
-50...+150°C
TS
-50...+175°C
Thermal Resistance Junction – Ambient air
Wärmewiderstand Sperrschicht – umgebende Luft
RthA
<70 K/W 1)
Thermal Resistance Junction – Terminal
Wärmewiderstand Sperrschicht – Anschluss
RthT
<30 K/W
Zener voltages see table on next page – Zener-Spannungen siehe Tabelle auf der nächsten Seite
23
1 Mounted on P.C. board with 25 mm2 copper pads at each terminal
Montage auf Leiterplatte mit 25 mm2 Kupferbelag (Lötpad) an jedem Anschluss
2 Tested with pulses – Gemessen mit Impulsen
3 The Z1SMA1 is a diode operated in forward mode. Hence, the index of all parameters should be “F” instead of “Z”.
The cathode, indicated by a white band has to be connected to the negative pole.
Die Z1SMA1 ist eine in Durchlass betriebene Si-Diode. Daher ist bei allen Kenn- und Grenzwerten der Index
“F” anstatt “Z” zu setzen. Die mit weißem Balken gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
© Diotec Semiconductor AG
http://www.diotec.com/
1