AP4310E Datasheet, PDF (3/9 Pages) Diodes Incorporated – DUAL OP AMP AND VOLTAGE REFERENCE

Absolute Maximum Ratings (Note 4)
A Product Line of
Diodes Incorporated
AP4310E
Symbol
VCC
VIN
VID
IK
PD
TJ
TSTG
TLEAD
Parameter
Power Supply Voltage (VCC to GND)
Op Amp1 and 2 Input Voltage Range (Pins 2, 5, 6)
Op Amp 2 Input Differential Voltage (Pins 5, 6)
Voltage Reference Cathode Current (Pin 3)
Power Dissipation (TA=+25°C)
Operating Junction Temperature
Storage Temperature Range
Lead Temperature (Soldering 10sec)
Rating
40
-0.3 to VCC+0.3
40
100
500
+150
-65 to +150
+260
Unit
V
V
V
mA
mW
C
C
C
Note 4: Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “Recommended Operating Conditions” is not implied.
Exposure to “Absolute Maximum Ratings” for extended periods may affect device reliability.
Recommended Operating Conditions (Note 5)
Parameter
Min
Supply Voltage
3
Ambient Temperature
-40
Note 5: Qualified for SMD on the underside of a PCB by processing the PCB through a wave soldering operation.
Max
36
+105
Unit
V
C
Electrical Characteristics (@VCC=5V, TA=+25C, unless otherwise specified.)
Parameters
Conditions
Min
Typ
Total Supply Current, excluding Current in ^{VCC=5V, no load, -40°C≤TA≤+105°C}
–
0.15
Voltage Reference
VCC=30V, no load, -40°C≤TA ≤+105°C
–
0.20
Voltage Reference Section
Reference Voltage
IK=10mA
TA=+25°C
2.49
2.50
-40°C≤TA ≤+105°C
2.48
2.50
Reference Voltage Deviation over Full
Temperature Range
IK=10mA, TA=-40°C to +105°C
–
5
Minimum Cathode Current for Regulation –
–
0.01
Dynamic Impedance
IK=1mA to 80mA, f<1kHz
–
0.2
Op Amp 1 Section (VCC=5V, VO=1.4V, TA=+25°C, unless otherwise noted.)
Input Offset Voltage
TA=+25°C
TA=-40°C to +105°C
–
0.5
–
–
Input Offset Voltage Temperature Drift
TA=-40°C to +105°C
–
7
Input Bias Current (Inverting Input Only) T_A=+25°C
–
20
Large Signal Voltage Gain
VCC=15V, RL=2kΩVO=1.4V to 11.4V
85
100
Power Supply Rejection Ratio
VCC=5V to 30V
70
90
AP4310E
Document number: DS36787 Rev. 3 - 2
3 of 9
www.diodes.com
Max
Unit
0.25
mA
0.30
2.51
V
2.52
24
mV
0.05
mA
0.5
Ω
3
mV
5
–
μV/°C
150
nA
–
dB
–
dB
September 2014
© Diodes Incorporated