ID100 Datasheet, PDF (1/4 Pages) Microsemi Corporation – SCRs .5 Amp, Planar

DIGITRON SEMICONDUCTORS
ID100-ID106
SILICON CONTROLLED RECTIFIER
0.5 AMP
Available Non-RoHS (standard) or RoHS compliant (add PBF suffix).
Available as “HR” (high reliability) screened per MIL-PRF-19500, JANTX level. Add “HR” suffix to base part number.
MAXIMUM RATINGS
Rating
Repetitive peak off state voltage
Repetitive peak reverse voltage
DC on-state current
75°C ambient
100°C case
Repetitive peak on-state current
Peak one cycle surge (non-repetitive) on-state
current
Peak gate current
Average gate current
Reverse gate voltage
Storage temperature range
Operating temperature range
Symbol
V_DRM
V_RRM
ID100
30
30
ID101
60
60
ID102
100
100
ID103
150
150
ID104
200
200
ID105
300
300
ID106
400
400
Unit
Volts
Volts
I_T
I_TRM
I_TSM
I_GM
I_G(AV)
V_GR
T_stg
T_J
250
0.5
6
Up to 30
250
25
6
-65 to 150
-65 to 125
mA
Amps
Amps
Amps
mA
mA
Volts
°C
°C
ELECTRICAL CHARACTERISTICS (T_A = 25°C unless otherwise noted)
Characteristics
Symbol Min Typ Max Unit
Test Condition
Off-state current (ID100-ID104)
Off-state current (ID105-ID106)
I_DRM
-
5.0 50 µA
- 10.0 100 µA
V_DRM = rating, R_GK = 1K, T = 125°C
V_DRM = rating, R_GK = 1K, T = 125°C
Reverse current (ID100-ID104)
Reverse current (ID105-ID106)
- 10.0 50 µA
V_RRM = rating, R_GK = 1K, T = 125°C
I_RRM
- 15.0 100 µA
V_RRM = rating, R_GK = 1K, T = 125°C
Gate trigger current
-
5.0 200 µA
V_D = 5V, R_GS = 10K
I_GT
-
-
500 µA
V_D = 5V, R_GS = 10K, T = -40°C
Gate trigger voltage
0.40 0.55 0.8 V
V_GT
-
-
1.0 V
V_D = 5V, R_GS = 100Ω
V_D = 5V, R_GS = 100Ω, T =- -40°C
0.10 -
-
V
V_D = 5V, R_GS = 100Ω, T = 125°C
Peak on-state voltage
V_TM
-
-
1.7 V
I_T = 1A (pulse)
Holding current
-
1.0 5.0 mA
I_H
-
- 10.0 mA
R_GK = 1K
R_GK = 1K, T = -40°C
Turn-on time
t_on
-
0.5
-
µs
I_G = 10mA, I_T = 1A, V_D = 30V
Circuit commutated turn-off time (ID100-ID104)
-
8.0
-
µs
t_q
Circuit commutated turn-off time (ID105-ID106)
- 15.0 -
µs
I_T = I_R = 1A, R_GK = 1KΩ
I_T = I_R = 1A, R_GK = 1KΩ
Blocking voltage ratings apply over the full operating temperature range, provided the gate is connected to the cathode through an appropriate resistor, 1000 ohms or smaller, or
other adequate gate bias is used.
144 Market Street
Kenilworth NJ 07033 USA
phone +1.908.245-7200
fax +1.908.245-0555
[e-mail]
www.digitroncorp.com
Rev. 20130116