|
DRP024V060W1AA_14 Datasheet, PDF (8/13 Pages) Delta Electronics, Inc. – CliQ DIN Rail Power Supply | |||
|
◁ |
TECHNICAL DATASHEET
CliQ DIN Rail Power Supply
24V 60W 1 Phase / DRP024V060W1AA
Safety Instructions
ï® Vertical Mounting
ï® Horizontal Mounting
â ALWAYS switch mains of input power OFF before connecting and disconnecting the input voltage to the unit. If mains are not
turned OFF, there is risk of explosion / severe damage.
â To guarantee sufficient convection cooling, keep a distance of 50mm above and below the device as well as a lateral
distance of 20mm to other units.
â Note that the enclosure of the device can become very hot depending on the surrounding air temperature and load of the power
supply. Risk of burns!
â Only plug in and unplug connectors when power is turned off!
â DO NOT insert any objects into the unit.
â Hazardous voltages may be present for up to 5 minutes after the input mains voltage is disconnected. Do not touch the unit during
this time.
â The power supplies unit must be installed in an IP54 enclosure or cabinet in the final installation. The enclosure or cabinet must
comply with EN 60079-0 or EN 60079-15.
â CAUTION: âFor use in a controlled environmentâ.
â Warning: Explosion Hazard - Substitution of components may impair suitability for Class I, Division 2.
â Warning: Explosion Hazard - Do not disconnect equipment unless the power has been switched off or the area is known to be non-
hazardous.
8
All parameters are specified at 25°C ambient unless otherwise indicated.
www.DeltaPSU.com (May 2014, Rev. 03)
|
▷ |