PMT-24V100W1AHA Datasheet, PDF (7/13 Pages) Delta Electronics, Inc. – PMT Panel Mount Power Supply

TECHNICAL DATASHEET
PMT Panel Mount Power Supply
24V 100W 1 Phase / PMT-24V100W1A□□
Assembly & Installation
Mounting holes for power supply assembly onto the mounting surface.
Ⓐ The power supply shall be mounted on minimum 2 mounting holes using M3 screw minimum 5mm length.
Ⓑ This surface belongs to customer’s end system or panel where the power supply is mounted.
Ⓒ Connector
Fig. 2.1 Side Mounting (Vertical)
Fig. 2.2 Base Mounting (Vertical)
Fig. 2.3 Side Mounting (Horizontal)
– PM☐-24V100W1AA☐ / PM☐-24V100W1AG☐: Use flexible cable (stranded or solid) of AWG No. 22-12. The torque at the
connector shall not exceed 13Kgf.cm. The insulation stripping length should not exceed 0.275” or 7mm.
– PM☐-24V100W1AH: Use flexible cable (stranded or solid) of AWG No. 22-18. Please refer to Table 1 for the recommended
Housing and Terminal.
Table 1
Connector (Board Mounting)
Housing
Terminal
Input (JWT)
Output (JWT)
A3963WV2-5P-A
A3963WV2-7P-U
A3963H02-5P
A3963H02-7P
A3963T0P-2
Improper Installations
7
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (May 2013, Rev. 00)