PMC-05V015W1AA Datasheet, PDF (7/11 Pages) Delta Electronics, Inc. – PMC Panel Mount Power Supply

TECHNICAL DATASHEET
PMC Panel Mount Power Supply
5V 15W 1 Phase / PMC-05V015W1AA
De-rating VS AC input voltage
■ No output power de-rating across the entire
input voltage range
Assembly & Installation
Mounting
Ⓐ Mounting holes for power supply assembly onto the mounting surface. Power supply shall be mounted on minimum 2 mounting
holes using M3 screw minimum 5 mm length.
Ⓑ The power supply shall be mounted on minimum 2 mounting holes using M3 screw only. The screw penetration into the chassis
must be ≤ 2 mm.
Ⓒ Connector.
ⒹThis surface belongs to customer’s end system or panel where the power supply is mounted.
Installation
Fig. 2 Mounting Orientation
 Only use M3 screw ≤ 2 mm through the base mounting holes. This is to
keep a safe distance between the screw and internal components.
 Recommended mounting tightening torque : 4~8Kgf.cm
7
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (March 2013, Rev. 00)