DRC-12V60W1AZ Datasheet, PDF (7/11 Pages) Delta Electronics, Inc. – Chrome DIN Rail Power Supply

TECHNICAL DATASHEET
Chrome DIN Rail Power Supply
12V 60W 1 Phase (Class II & NEC Class 2) / DRC-12V60W1AZ
Output De-rating VS. Input Voltage
 No output power de-rating across the entire
input voltage range
Assembly & Installation
The power supply unit (PSU) can be mounted on 35mm DIN rails in accordance with EN 60715. The device should be installed with
input terminal block at the bottom.
Each device is delivered ready to install.
Mounting
Dismounting
Fig. 2.1 Mounting
Snap on the DIN rail as shown in Fig. 2.1:
1. Tilt the unit upwards and insert it onto the DIN rail.
2. Push downwards until stopped.
3. Press against the bottom front side for locking.
4. Shake the unit slightly to ensure that it is secured.
Fig. 2.2 Dismounting
To uninstall, pull or slide down the latch with screw driver as
shown in Fig. 2.2. Then slide the power supply unit (PSU) in
the opposite direction, release the latch and pull out the power
supply unit (PSU) from the rail.
7
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (November 2013, Rev. 00)