SA01S Datasheet, PDF (2/4 Pages) Delta Electronics, Inc. – 1W DC/DC CONVERTER, SMD-Package

Output Characteristics
Parameter
Output Voltage Accuracy
Line Regulation
Load Regulation
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Temperature Coefficient
Short Circuit Protection
Conditions
For Vin Change of 1%
Io=20% to 100%
Over Line, Load & Temp.
Min.
Typ.
Max.
Unit
---
±1.0
±3.0
%
---
±1.2
±1.5
%
See Model Selection Guide
---
60
120
mV P-P
---
---
150
mV P-P
---
---
15
mV rms
---
±0.01
±0.02
%/℃
0.5 Second Max.
General Characteristics
Parameter
Conditions
I/O Isolation Voltage (rated)
60 Seconds
I/O Isolation Resistance
500 VDC
I/O Isolation Capacitance
100KHz, 1V
Switching Frequency
MTBF (calculated)
MIL-HDBK-217F@25℃, Ground Benign
Moisture Sensitivity Level (MSL)
IPC/JEDEC J-STD-020D
Min.
1000
1000
---
50
2,000,000
Typ.
Max.
---
---
---
---
40
100
100
140
---
---
Level 3
Unit
VDC
MΩ
pF
KHz
Hours
Recommended Input Fuse
5V Input Models
500mA Slow-Blow Type
12V Input Models
200mA Slow-Blow Type
24V Input Models
100mA Slow-Blow Type
Environmental Specifications
Parameter
Operating Temperature Range (with Derating)
Case Temperature
Storage Temperature Range
Humidity (non condensing)
Cooling
Lead Temperature (1.5mm from case for 10Sec.)
Conditions
Ambient
Min.
Max.
-40
+85
---
+90
-50
+125
---
95
Free-Air convection
---
260
Unit
℃
℃
℃
% rel. H
℃
Power Derating Curve
(5V & 12Vin)
(24Vin)
Notes
1 Specifications typical at Ta=+25℃, resistive load, nominal input voltage and rated output current unless otherwise noted.
2 Ripple & Noise measurement bandwidth is 0-20MHz.
3 These power converters require a minimum output loading to maintain specified regulation, operation under no-load conditions will not
damage these modules; however they may not meet all specifications listed.
4 All DC/DC converters should be externally fused at the front end for protection.
5 Specifications subject to change without notice.
DS_SA01S_03152012
E-mail: [e-mail]
http://www.delta.com.tw/dcdc
P2