LNE-150W Datasheet, PDF (14/15 Pages) Delta Electronics, Inc. – North American and International AC voltage options

TECHNICAL DATASHEET
LED Driver
LNE-150W Series / LNE-□V150W□□□
3. Please DO NOT connect "DIM-" to "V-".
4. Reference resistance value for output current adjustment (Typical).
5. 1 ~ 10V dimming function for output current adjustment (Typical).
6. 10V PWM signal for output current adjustment is also possible. For additional information, please contact your Delta sales
representative.
7. Please note that LNE-☐V150WD☐☐ can't turn the lighting fixture completely off (totally dark) by using any of these dimming
adjustment methods. To completely turn off the lighting fixture, the input AC voltage must be removed. See illustration on
previous page.
External Input Protection Device
The unit is protected at the L pin, with an internal fuse that cannot be replaced. The power supply has been tested and approved on
20A branch circuits without additional protection device. An external protection device is only required if the supplying branch has an
ampacity greater than above. Thus, if an external protective device is necessary, a 20 Ampere C-characteristic circuit breaker can be
utilized.
14
All parameters are specified at 25°C ambient for all products unless otherwise indicated.
www.DeltaPSU.com (April 2016, Rev. 02)