LNE-185W Datasheet, PDF (13/15 Pages) Delta Electronics, Inc. – North American and International AC voltage options

TECHNICAL DATASHEET
LED Driver
LNE-185W Series / LNE-□V185W□□□
Operating Methods of LED Modules-CV and CC Operation
A typical LED power supply is able to either work in "constant
voltage mode (CV) or constant current mode (CC)" to drive the
LEDs. DELTA’s LNE drivers integrate CV+CC characteristics; so
operation in CV mode (with external LED driver), in region Ⓐ or
CC mode (direct drive, at area Ⓑ).
In the constant current region, the highest voltage at the output
of the driver depends on the configuration of the end systems.
Should there be any compatibility issues or other questions with
these adjustment methods, please contact with Delta.
Dimming Operations
This operation is available for LNE-☐V185WD☐☐only.
The Dimming connection diagram for turning the lighting fixture ON/OFF can be configured as below.
LNE-☐V185WD☐☐
Please refer an example of reference configuration as follows.
1. Built-in 3 in 1 dimming function, IP67 rated. Output constant current level can be adjusted through output cable by connecting
a resistance or 1~10Vdc or 10V PWM signal between DIM+ and DIM-.
2. The LED lighting fixture can be turned ON/OFF by the switch.
13
All parameters are specified at 25°C ambient for all products unless otherwise indicated.
www.DeltaPSU.com (April 2016, Rev. 02)