DRL-24V240W1AX Datasheet, PDF (11/15 Pages) Delta Electronics, Inc. – Built-in constant current circuit for reactive loads

TECHINCAL DATASHEET
LYTE DIN Rail Power Supply
24V 240W 1 Phase / DRL-24V240W1A□
Safety Instructions
 Vertical Mounting
– ALWAYS switch mains of input power OFF before connecting and
disconnecting the input voltage to the unit. If mains are not turned
OFF, there is risk of explosion / severe damage.
– To guarantee sufficient convection cooling, keep a distance
of 50mm (1.96 inch) above and 18cm (7.08 inch) below the
device as well as a lateral distance of 10mm (0.39 inch) to
other units.
– Note that the enclosure of the device can become very hot
depending on the surrounding air temperature and load of the
power supply. Risk of burns!
– The main power must be turned off before connecting or
disconnecting wires to the terminals.
– DO NOT insert any objects into the unit.
– Hazardous voltages may be present for up to 5 minutes after the
input mains voltage is disconnected. Do not touch the unit during
this time.
– The power supplies are built in units and must be installed in a
cabinet or room (condensation free environment and indoor
location) that is relatively free of conductive contaminants.
11
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (May 2016, Rev. 01)