DRL-24V120W1AX Datasheet, PDF (11/15 Pages) Delta Electronics, Inc. – Universal AC input voltage

TECHNICAL DATASHEET
LYTE DIN Rail Power Supply
24V 120W 1 Phase / DRL-24V120W1A□
Safety Instructions
 Vertical Mounting
– ALWAYS switch mains of input power OFF before connecting and
disconnecting the input voltage to the unit. If mains are not turned OFF,
there is risk of explosion / severe damage.
– To guarantee sufficient convection cooling, keep a distance of 50mm
(1.96 inch) above and 18cm (7.08 inch) below the device as well as a
lateral distance of 10mm (0.39 inch) to other units.
– Note that the enclosure of the device can become very hot depending on
the surrounding air temperature and load of the power supply. Risk of
burns!
– The main power must be turned off before connecting or disconnecting
wires to the terminals.
– DO NOT insert any objects into the unit.
– Hazardous voltages may be present for up to 5 minutes after the input
mains voltage is disconnected. Do not touch the unit during this time.
– The power supplies are built in units and must be installed in a cabinet or
room (condensation free environment and indoor location) that is relatively
free of conductive contaminants.
11
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (January 2016, Rev. 01)