PJ-12V150WBNA Datasheet, PDF (10/14 Pages) Delta Electronics, Inc. – PJ Open Frame Power Supply

TECHNICAL DATASHEET
PJ Open Frame Power Supply
12V 150W 1 Phase / PJ-12V150W□□A
Output De-rating VS. Input Voltage
■ No output power de-rating for the input voltage
range from 90Vac to 264Vac
Functional Manual
Remote ON/OFF Function
You can remotely control the power supply unit
to turn ON/OFF by using an external DC source.
Follow the DC power source voltage and current
limiting defined in the table below.
Built-in Resistor R_i (ohm)
1k
Voltage Between RC+ and RC- (V)
Output ON
Output OFF
5-12.5
0-0.5
Input Current (mA)
20 Max
Notes
1. Remote ON/OFF circuits are isolated from input, output and PE.
2. Please check if the polarity of the wire connector is the same as the external DC source. If not, the power would not turn on and
the internal components may be damaged.
3. You do not need an external resistance R_O for current limit while the output voltage of external DC source is within the range of
5-12.5V. If the output voltage exceeds 12.5V, please use the following equation for the value of current limit resistance R_O.
𝑅_𝑂
=
𝑉𝑐𝑐
−
(3.5 + 0.006𝑅_𝑖)
0.006
10
All parameters are specified at 25°C ambient unless otherwise noted.
www.DeltaPSU.com (May 2013, Rev. 00)