MDS-200APB24AA Datasheet, PDF (10/11 Pages) Delta Electronics, Inc. – Medical AC-DC Enclosed Power Supply

Medical AC-DC Enclosed Power Supply
24V 200W 2”x4” High Density / MDS-200APB24 AA
Power Good
Power Good+ pin is an open collector transistor (40V/600mA
rating). A resistor (suggested value 20Kohm, 1/8W) can be added
between output pin (or, other available pull-up voltage that is no
greater than 30V) and the Power Good+ pin (refer to figure
below). Value of pull-up resistor may have to be adjusted,
depending on voltage used, and other end-use conditions of the
Power Good+ pin connection to the product. When AC input is
on, Power Good+ pin will be high. When AC input is off, Power
Good+ pin will be low. There will be a minimum of 5 milliseconds
(with 120W convection output power) between the time the power
good goes to low level, and the time when the output reaches
90% of its rated value.
10
All parameters are specified at 25°C ambient unless otherwise noted.
(November 2016, Rev. 07)