E36SR05015NRFA Datasheet, PDF (10/15 Pages) Delta Electronics, Inc. – Delphi Series E36SR, 75W Eighth Brick Family DC/DC Power Modules: 18~75V in, 3.3V/20A out

THERMAL CONSIDERATIONS
Thermal management is an important part of the system
design. To ensure proper, reliable operation, sufficient
cooling of the power module is needed over the entire
temperature range of the module. Convection cooling is
usually the dominant mode of heat transfer.
Hence, the choice of equipment to characterize the
thermal performance of the power module is a wind
tunnel.
Thermal Testing Setup
Delta’s DC/DC power modules are characterized in
heated vertical wind tunnels that simulate the thermal
environments encountered in most electronics
equipment. This type of equipment commonly uses
vertically mounted circuit cards in cabinet racks in which
the power modules are mounted.
The following figure shows the wind tunnel
characterization setup. The power module is mounted
on a test PWB and is vertically positioned within the
wind tunnel. The space between the neighboring PWB
and the top of the power module is constantly kept at
6.35mm (0.25’’).
FANCING PWB
PWB
MODULE
AIR VELOCITY
AND AMBIENT
TEMPERATURE
SURED BELOW
THE MODULE
AIR FLOW
Note: Wind Tunnel Test Setup Figure Dimensions are in millimeters and (Inches)
Figure 20: Wind tunnel test setup
DS_E36SR05015_10292013
Thermal Derating
Heat can be removed by increasing airflow over the module.
The hottest point temperature of the module is +122°C. To
enhance system reliability; the power module should always
be operated below the maximum operating temperature. If the
temperature exceeds the maximum module temperature,
reliability of the unit may be affected.
THERMAL CURVES
Figure 21: Hot spot temperature measured point.
＊ The allowed maximum hot spot temperature is defined at 122℃
E36SR05015(Standard) Output Current vs. Ambient Temperature and Air Velocity
Output Current(A)
16
@Vin = 24V (Transverse Orientation)
14
12
Natural
Convection
10
100LFM
200LFM
300LFM
8
400LFM
6
500LFM
600LFM
4
2
0
20
25
30
35
40
45
50
55
60
65
70
75
80
85
Ambient Temperature (℃)
Figure 22: Output current vs. ambient temperature and air velocity @
Vin=24V(Transverse Orientation)
E36SR05015(Standard) Output Current vs. Ambient Temperature and Air Velocity
Output Current(A)
16
@Vin = 48V (Transverse Orientation)
14
Natural
12
Convection
10
100LFM
8
6
4
200LFM
300LFM
400LFM
500LFM
600LFM
2
0
20
25
30
35
40
45
50
55
60
65
70
75
80
85
Ambient Temperature (℃)
Figure 23: Output current vs. ambient temperature and air velocity @
Vin=48V(Transverse Orientation)
10