1E-2M Datasheet, PDF (1/2 Pages) DB Lectro Inc – T-circuit design required by the ATE market.

1E 2 FormA Series
Miniature
Surface Mount
PRODUCT DESCRIPTIONS
The 1E 2 FormA Series was especially designed for high
performance T-circuit design required by the ATE market.
The difference between this series and 3E Series is that
the former is capable of keeping open state during system
calibration.
As an added feature, the two switches are configured
within the relay as a single package, minimizing the
physical length of the stub.
SPECIFICATIONS
1E 2FormA Series
Parameters
Coil Specifications
Units
Nominal Coil Voltage
Coil Resistance
Operate Voltage
Release Voltage
VDC
Ω
VDC Max
VDC Min
Contact Ratings
Switching Voltage
Switching Current
Carry Current
Contact Rating
Life Expectancy
Contact Resistance
Contact Resistance Stability
Volts
Amps
Amps
Watts
x10⁶ Cycle
mΩ
mΩ
Relay Specifications
Insulation Resistance
Ω Min
1E -2M12G 1E -2M22G
2 Form A
5.0
12.0
150
500
3.5
8.3
0.7
1.2
100
0.5
1.0
10
300
150
5.0
10¹¹
Dielectric Strength
Operate Time
(Including Bounce)
Release Time
VDC Min
VDC Min
VDC Min
msec Max
msec Max
Environmental Ratings
Measurement Reference Conditions
Temp: 15˚C to 35˚C
Humidity: 25% to 75%RH
Atmospheric Pressure: 860 to 1060hpa
150
250
250
0.5
0.5
Storage temp: -40˚C to +85˚C
Operate temp: -20˚C to +60˚C
Vibration: 20G’s to 2000Hz
Shock: 50G’s
G: Gull-Wing
Test Conditions
±10% @ 20˚C
15˚C to 35˚C
15˚C to 35˚C
Max DC/Peak AC resistance
Max DC/Peak AC resistance
Max DC/Peak AC resistance
Max DC/Peak AC resistance
@ 1V 10mA
Max initial @ operate voltage
Max initial @ operate voltage
Between all isolated pins
@ 100V 20˚C 40%RH
Between contacts
Contacts to shield
Contacts/Shield to coil
@ nominal coil voltage
100Hz square wave
Diode suppression