DS1099 Datasheet, PDF (5/6 Pages) Dallas Semiconductor – Low-Frequency Dual EconOscillator

Low-Frequency Dual EconOscillator
Functional Diagram
V_CC
V_CC
MASTER
OSCILLATOR
1.048MHz
GND
f_MOSC
FACTORY-
PROGRAMMED
EEPROM
DIVIDER 0
DIVIDE BY 2^X
(X = X₀ = 0...22)
DIVIDER 1
DIVIDE BY 2^X
(X = X₁ = 0...22)
OE0
OE1
DS1099
OUTPUT ^fOUT0 _OUT0
DRIVER
OUTPUT ^fOUT1 _OUT1
DRIVER
Detailed Description
The DS1099 consists of a fixed-frequency 1.048MHz
master oscillator followed by two independent factory-
programmable dividers. The two divider outputs are
connected to pins OUT0 and OUT1, which are inde-
Table 1. Divider Settings and Output
Frequencies
DIVIDER SETTING
X₀ OR X₁
0
1
2
3
4
5
—
19
20
21
22
DIVISOR
1
2
4
8
16
32
—
524,288
1,048,576
2,097,152
4,194,304
f_OUT0 OR f_OUT1
1.048MHz
0.524MHz
0.262MHz
0.131MHz
65.50kHz
32.75kHz
—
2Hz
1Hz
0.5Hz
0.25Hz
pendently enabled/disabled using the output-enable
pins, OE0 and OE1, respectively. When the output-
enable pins are active (low), the corresponding outputs
are enabled. If either output-enable pin is tied to its
inactive state (high), then the corresponding output is
disabled and forced high immediately. The output-
enable pins only disable the corresponding output
driver(s) and do not shut down the master oscillator or
the dividers.
Since the master oscillator frequency, f_MOSC, is fixed,
the frequency of OUT0 and OUT1 is determined by
DIVIDER 0 and DIVIDER 1, respectively. And since
each output has its own divider, f_OUT0 and f_OUT1 can
be programmed independent of each other.
The frequency of the outputs are calculated as follows:
f_OUT0 = f_MOSC / 2^X0 = 1.048MHz / 2^X0
f_OUT1 = f_MOSC / 2^X1 = 1.048MHz / 2^X1
where X₀ is the DIVIDER 0 setting and X₁ is the
DIVIDER 1 setting. Valid values for X₀ and X₁ are inte-
gers 0 to 22 (dec).
Table 1 shows output frequencies and divider values
for the range of divider settings.
_____________________________________________________________________ 5