DS1410D Datasheet, PDF (2/2 Pages) Dallas Semiconductor – Parallel Port Button Holder

DS1410D
DS1410D SOFTWARE
The DS1410D Development Kit contains access sys-
tem software which must be linked with the application
software in order to complete integration. The support
for the application development environments and
operating systems lies in the interface software of the
access system. The access system contains the low
level interface for communicating with the Buttons.
NOTE: The DS1410D is not object code compatible
with the DS1410. However, both object modules can
co–exist to provide support for both holders.
DS1410D HARDWARE
The DS1410D passes through all the parallel port I/O
lines, which allows them to be stacked with other
DS1410D’s or other parallel port resident devices.
The DS1410D attaches directly to the PC parallel port.
If use of a printer is desired, the DS1410D should reside
between the parallel port and the printer cable. With
system and printer both off, simply plug the 25–pin male
D connector side of the DS1410D into the PC parallel
port and then plug the printer cable into the 25–pin
female D connector side of the DS1410D. The top and
bottom screws that reside on the DS1410D and the
printer cable should then be tightened accordingly.
Attaching another parallel port device is not required to
operate the DS1410D.
To cascade DS1410D’s, simply follow the same direc-
tions as above, inserting DS1410D 25–pin D male and
female connectors accordingly.
021798 2/2