DS1621 Datasheet, PDF (15/16 Pages) Dallas Semiconductor – Digital Thermometer and Thermostat

NOTES:
1. All voltages are referenced to ground.
DS1621
2. I/O pins of fast mode devices must not obstruct the SDA and SCL lines if V_DD is switched off.
3. I_CC specified with T_OUT pin open.
4. I_CC specified with V_CC at 5.0V and SDA, SCL = 5.0V, 0°C to 70°C.
5. After this period, the first clock pulse is generated.
6. A device must internally provide a hold time of at least 300 ns for the SDA signal (referred to the
V_{IH MIN} of the SCL signal) in order to bridge the undefined region of the falling edge of SCL.
7. The maximum t_HD:DAT has only to be met if the device does not stretch the LOW period (t_LOW) of the
SCL signal.
8. A fast mode device can be used in a standard mode system, but the requirement t_SU:DAT >250 ns must
then be met. This will automatically be the case if the device does not stretch the LOW period of the
SCL signal. If such a device does stretch the LOW period of the SCL signal, it must output the next
data bit to the SDA line t_RMAX+t_SU:DAT = 1000+250 = 1250 ns before the SCL line is released.
9. C_b – total capacitance of one bus line in pF.
10. Writing to the nonvolatile memory should only take place in the 0°C to 70°C temperature range.
11. See typical curve for specification limits outside 0°C to 70°C range. Thermometer error reflects
sensor accuracy as tested during calibration.
TIMING DIAGRAM
15 of 16
102299