KBPC25005 Datasheet, PDF (1/2 Pages) Shanghai Sunrise Electronics – SINGLE PHASE SILICON BRIDGE RECTIFIER

KBPC25005/W THRU KBPC2510/W
CURRENT 25.0 Amperes
VOLTAGE 50 to 1000 Volts
Features
· Diffused Junction
· Low Reverse Leakage Current
· Low Power Loss, High Efficiency
· Surge Overload Rating to 400A Peak
· Electrically Isolated Metal Case for Maximum
Heat Dissipation
· High Case Dielectric Strength of 1500VRMS
Mechanical Data
· Case : High Conductivity Metal
· Terminals : Plated Leads Solderable per
MIL-STD-202, Method 208
· Polarity : Symbols Marked on Case
· Mounting : Through Hole for #10 Screw
· Mounting Torque : 8.0 Inch-pounds Maximum
· Weight : KBPC
31.6 grams (approx.)
KBPC-W
28.5 grams (approx.)
· Mounting Position : Any
· Marking : Type Number
Maximum Ratings And Electrical Characteristics
KBPC
H
K B P C -W
H
B
E
N
M
L
A
C
H
(AC)
J
(-)
(+)
(AC)
CA
G
(AC)
P
(-)
A
P
H
(+)
KA
(AC)
K B P C / K B P C -W
Dim Min Max Dim Min Max
A
28.40 28.70
J
17.10 19.10
B
10.97 11.23
K
10.40 12.40
C
15.50 17.60
L
0.97 O_/ 1.07 O_/
E
22.86 25.40
M 30.50
G
13.30 15.30
N
10.97 11.23
Hole for #10 screw P
H
4.85 O_/ 5.59 O_/
17.10 19.10
All Dimens ions in mm
"W" S uffix Des ignates Wire Leads
No S uffix Des ignates F as t-on T erminals
(Ratings at 25 ambient temperature unless otherwise specified, Single phase, half wave 60Hz, resistive or inductive
load. For capacitive load, derate by 20%)
Symbols
KBPC25 KBPC25 KBPC25 KBPC25 KBPC25 KBPC25 KBPC25
005/W 01/W 02/W 04/W 06/W 08/W 10/W
Peak Repetitive Reverse voltage
Working Peak Reverse voltage
DC Blocking voltage
VRMM
VRWM
VR
50
100
200 400 600
800 1000
RMS Reverse voltage
VR(RMS)
35
70
140
280
420
560
700
Average Rectified Output Current @ TC=55
Io
25
Non-Repetitive Peak Forward Surge Current,
8.3ms single half-sine-wave superimposed
IFSM
400
on rated load (JEDEC method)
Forward voltage (per element)
@ IF=12.5 A
VFM
1.2
Peak Reverse Current at Rated
DC Blocking voltage
@ TC=25
@ TC=125
IR
10
1.0
I²t Rating for Fusing (t<8.3ms) (Note 2)
I²t
373
Typical Junction Capacitance (Note 3)
Cj
300
Typical Thermal Resistance Junction to Case
Operating and Storage Temperature Range
R JA
Tj
TSTG
3.8
-65 to +150
Units
Volts
Volts
Amps
Amps
Volts
A
mA
A^2S
pF
/W
Notes:
(1) Thermal resistance junction to case mounted on heat sink.
(2) Measured at non-repetitive, for t > 1.0ms and < 8.3ms.
(3) Measured at 1.0MHz and applied reverse voltage of 4.0V DC.