FM25040B-GA Datasheet, PDF (5/14 Pages) Cypress Semiconductor – Automotive Temp. 4Kb Serial 5V F-RAM Memory

Data Transfer
All data transfers to and from the FM25040B occur
in 8-bit groups. They are synchronized to the clock
signal (SCK) and they transfer most significant bit
(MSB) first. The serial input data is clocked in on
the rising edge of SCK. The serial data output is
driven from the falling edge of SCK.
Command Structure
There are six commands called op-codes that can be
issued by the bus master to the FM25040B. They are
listed in the table below. These op-codes control the
functions performed by the memory. They can be
divided into three categories. First, there are
commands that have no subsequent data transfer.
They perform a single function, such as, enabling a
write operation. Second are commands followed by
one byte, either in or out. They operate on the Status
Register. Third are commands for memory
transactions followed by address and one or more
bytes of data.
Table 1. Op-code Commands
Name Description
WREN Set Write Enable Latch
WRDI Write Disable
RDSR Read Status Register
WRSR Write Status Register
READ Read Memory Data
WRITE Write Memory Data
Op-code
0000_0110b
0000_0100b
0000_0101b
0000_0001b
0000_A011b
0000_A010b
FM25040B - Automotive Temp.
WREN - Set Write Enable Latch
The FM25040B will power up with writes disabled.
The WREN command must be issued prior to any
write operation. Sending the WREN op-code will
allow the user to issue subsequent op-codes for
write operations. These include writing the Status
Register and writing the memory.
Sending the WREN op-code causes the internal
Write Enable Latch to be set. A flag bit in the Status
Register, called WEL, indicates the state of the
latch. WEL=1 indicates that writes are permitted. A
write to the Status Register has no effect on the
WEL bit. Completing any write operation will
automatically clear the write-enable latch and
prevent further writes without another WREN
command. Figure 5 below illustrates the WREN
command bus configuration.
WRDI - Write Disable
The WRDI command disables all write activity by
clearing the Write Enable Latch. The user can verify
that writes are disabled by reading the WEL bit in
the Status Register and verifying that WEL=0.
Figure 6 illustrates the WRDI command bus
configuration.
Figure 5. WREN Bus Configuration
Figure 6. WRDI Bus Configuration
Document Number: 001-86151 Rev. **
Page 5 of 14