CY7C68001 Datasheet, PDF (41/42 Pages) Cypress Semiconductor – EZ-USB SX2™ High-Speed USB Interface Device

FO R
FO R
CY7C68001
17.0 Document Revision History
Description Title: CY7C68001 EZ-USB SX2™ High-Speed USB Interface Device
Document Number: 38-08013
Origin of
REV. ECN No. Issue Date Change
Description of Change
** 111807 06/07/02
BHA New Data Sheet
*A 123155 02/07/03
BHA
Minor clean-up and clarification
Removed references to IRQ Register and replaced them with references to
Interrupt Status Byte
Modified pin-out description for XTALIN and XTALOUT
Added CS# timing to Figure 11-10, Figure 11-8, and Figure 11-12
Changed Command Protocol example to IFCONFIG (0x01)
Edited PCB Layout Recommendations
Added AR#10691
Added USB high-speed logo
*B 126324 07/02/03
MON
Default state of registers specified in section where the register bits are defined
Reorganized timing diagram presentation: First all timing related to synchronous
interface, followed by timing related to asynchronous interface, followed by timing
diagrams common to both interfaces
Provided further information in section 3.3 regarding boot methods
Provided timing diagram that encapsulates ALL relevant signals for a synchronous
and asynchronous slave read and write interface
Added section on (QFN) Package Design Notes
FIFOADR[2:0] Hold Time (t_FAH) for Asynchronous FIFO Interface has been updated
as follows: SLRD/PKTEND to FIFOADR[2:0] Hold Time: 20 ns; SLWR to
FIFOADR[2:0] Hold Time:70 ns (recommended)
Added information on the polarity of the programmable flag
Fixed the Command Synchronous Write Timing Diagram
Fixed the Command Asynchronous Write Timing Diagram
Added information on the delay required when endpoint configuration registers are
changed after SX2 has already enumerated
*C 129463 10/07/03
MON
Added Test ID for the USB Compliance Test
Added information on the fact that the SX2 does not automatically respond to
Set/Clear Feature Endpoint (Stall) request, external master intervention required
Added information on accessing undocumented register which are not indexed (for
resetting data toggle)
Added information on requirement of clock stability before releasing reset
Added information on configuration of PF register for full speed
Updated confirmed timing on FIFOADR[2:0] Hold Time (t_FAH)for Asynchronous
FIFO Interface has been updated
Corrected the default bit settings of EPxxFLAGS register
Added information on how to change SLWR/SLRD/SLOE polarities
Added further information on buffering interrupt on initiation of a command read
request
Change the default state of the FNADDR to 0x00
Added further labels on the sequence diagram for synchronous and asynchronous
read and write in single and burst mode
Added information on the maximum delay allowed between each descriptor byte
write once a command write request to register 0x30 has been initiated by the
external master
Document #: 38-08013 Rev. *E
Page 41 of 42