CY7C64013 Datasheet, PDF (41/48 Pages) Cypress Semiconductor – Full-Speed USB (12 Mbps) Function

CY7C64013
CY7C64113
21.0 Absolute Maximum Ratings
Storage Temperature ..........................................................................................................................................–65°C to +150°C
Ambient Temperature with Power Applied .................................................................................................................0°C to +70°C
Supply voltage on V_CC relative to V_SS .................................................................................................................... –0.5V to +7.0V
DC Input Voltage........................................................................................................................................... –0.5V to +V_CC+0.5V
DC Voltage Applied to Outputs in High Z State ............................................................................................ –0.5V to +V_CC+0.5V
Power Dissipation ..............................................................................................................................................................500 mW
Static Discharge Voltage ................................................................................................................................................... >2000V
Latch-up Current ............................................................................................................................................................ >200 mA
Max Output Sink Current into Port 0, 1, 2, 3, and DAC[1:0] Pins ...................................................................................... 60 mA
Max Output Sink Current into DAC[7:2] Pins ...................................................................................................................... 10 mA
22.0 Electrical Characteristics
f_OSC = 6 MHz; Operating Temperature = 0 to 70°C, V_CC = 4.0V to 5.25V
Parameter
Conditions
General
V_REF
V_pp
I_CC
I_SB1
I_ref
I_il
Reference Voltage
Programming Voltage (disabled)
V_CC Operating Current
Supply Current—Suspend Mode
V_REF Operating Current
Input Leakage Current
USB Interface
3.3V ±5%
No GPIO source current
Note 5
Any pin
V_di
V_cm
V_se
C_in
I_lo
R_ext
R_UUP
t_vccs
Differential Input Sensitivity
| (D+)–(D–) |
Differential Input Common Mode Range
Single Ended Receiver Threshold
Transceiver Capacitance
Hi-Z State Data Line Leakage
External USB Series Resistor
0 V < V_in < 3.3 V
In series with each USB pin
External Upstream USB Pull-up Resistor
Power On Reset
V_CC Ramp Rate
USB Upstream
1.5 kΩ ±5%, D+ to V_REG
Linear ramp 0V to V_CC[4]
V_UOH
V_UOL
Z_O
Static Output High
Static Output Low
USB Driver Output Impedance
General Purpose I/O (GPIO)
15 kΩ ±5% to Gnd
1.5 kΩ ±5% to V_REF
Including R_ext Resistor
R_up
Pull-up Resistance (typical 14 kΩ)
V_ITH
Input Threshold Voltage
All ports, LOW to HIGH edge
V_H
Input Hysteresis Voltage
All ports, HIGH to LOW edge
V_OL
Port 0,1,2,3 Output Low Voltage
I_OL = 3 mA
I_OL = 8 mA
V_OH
Output High Voltage
I_OH = 1.9 mA (all ports 0,1,2,3)
Notes:
4. Power-on Reset occurs whenever the voltage on V_CC is below approximately 2.5V.
5. This is based on transitions every 2 full-speed bit times on average.
Min. Max. Unit
3.15 3.45
V
–0.4 0.4
V
50
mA
50
µA
30
mA
1
µA
0.2
V
0.8 2.5
V
0.8 2.0
V
20
pF
–10 10
µA
19
21
Ω
1.425 1.575 kΩ
0
100
ms
2.8 3.6
V
0.3
V
28
44
Ω
8.0 24.0
kΩ
20% 40% V_CC
2%
8%
V_CC
0.4
V
2.0
V
2.4
V
Document #: 38-08001 Rev. **
Page 41 of 48