CYBLE-01201X-X0 Datasheet, PDF (29/38 Pages) Cypress Semiconductor – EZ-BLETM PRoCTM Module

CYBLE-012011-00
CYBLE-012012-10
Environmental Specifications
Environmental Compliance
This Cypress BLE module is built in compliance with the Restriction of Hazardous Substances (RoHS) and Halogen Free (HF)
directives. The Cypress module and components used to produce this module are RoHS and HF compliant.
RF Certification
The CYBLE-012011-00 module will be certified under the following RF certification standards at production release.
■ FCC: WAP2011
■ CE
■ IC: 7922A-2011
■ MIC: 203-JN0509
■ KC: MSIP-CRM-Cyp-2011
Safety Certification
The CYBLE-01201X-X0 module complies with the following regulations:
■ Underwriters Laboratories, Inc. (UL) - Filing E331901
■ CSA
■ TUV
Environmental Conditions
Table 51 describes the operating and storage conditions for the Cypress BLE module.
Table 51. Environmental Conditions for CYBLE-01201X-X0
Description
Operating temperature
Operating humidity (relative, non-condensation)
Thermal ramp rate
Storage temperature
Storage temperature and humidity
ESD: Module integrated into system
Components^[8]
Minimum Specification
-40 °C
5%
–
–40 °C
–
–
Maximum Specification
85 °C
85%
3 °C/minute
85 °C
85 ° C at 85%
15 kV Air
2.2 kV Contact
ESD and EMI Protection
Exposed components require special attention to ESD and electromagnetic interference (EMI).
A grounded conductive layer inside the device enclosure is suggested for EMI and ESD performance. Any openings in the enclosure
near the module should be surrounded by a grounded conductive layer to provide ESD protection and a low-impedance path to ground.
Device Handling: Proper ESD protocol must be followed in manufacturing to ensure component reliability.
Note
8. This does not apply to the RF pins (ANT, XTALI, and XTALO). RF pins (ANT, XTALI, and XTALO) are tested for 500-V HBM.
Document Number: 002-02521 Rev. *B
Page 29 of 38