W184 Datasheet, PDF (2/8 Pages) Cypress Semiconductor – Six Output Peak Reducing EMI Solution

W184
Pin Definitions
Pin Name
CLK0:5
CLKIN or X1
Pin No.
9, 11, 12, 13,
15, 17
3
NC or X2
4
SS%
6
Reset
23
REFOUT
14
EN1:2
SSON#
18, 7
24
FS1:2
VDD
22, 2
10, 16, 20, 21
Pin
Type
O
I
I
I
I
O
I
I
I
P
Pin Description
Modulated Frequency Outputs: Frequency modulated copies of the unmod-
ulated input clock (SSON# asserted).
Crystal Connection or External Reference Frequency Input: This pin has
dual functions. It may either be connected to an external crystal, or to an
external reference clock.
Crystal Connection: If using an external reference, this pin must be left un-
connected.
Modulation Width Selection: When Spread Spectrum feature is turned on,
this pin is used to select the amount of variation and peak EMI reduction that
is desired on the output signal. This pin has an internal pull-up resistors.
ModulationProfile Restart: A rising edge on this input restarts the modulation
pattern at the beginning of its defined path. This pin has an internal pull-down
resistor.
Non-Modulated Output: This pin provides a copy of the reference frequency.
This output will not have the Spread Spectrum feature enabled regardless of
the state of logic input SSON#.
Output Enable Select Pins: These pins control the activity of specific output
buffers. Set them to disable unused outputs using Table 3 as a guide.
Spread Spectrum Control (Active LOW): Asserting this signal (active LOW)
turns the internal modulation waveform on. This pin has an internal pull-down
resistor.
Frequency Selection Bit 1 and 2: These pins select the frequency of opera-
tion. Refer to Table 1. These pins have internal pull-up resistors.
Power Connection: Connected to 3.3V or 5V power supply.
2