CY8C29666-12PVXET Datasheet, PDF (18/35 Pages) Cypress Semiconductor – Automotive – Extended Temperature PSoC® Programmable System-on-Chip

CY8C29466, CY8C29666
DC Operational Amplifier Specifications
The following tables list guaranteed maximum and minimum specifications for the voltage and temperature ranges: 4.75 V to 5.25 V
and –40 °C  T_A  125 °C. Typical parameters apply to 5 V at 25 °C and are for design guidance only.
The Operational Amplifier is a component of both the Analog Continuous Time (CT) PSoC blocks and the Analog Switched Capacitors
(SC) PSoC blocks. The guaranteed specifications are measured in the Analog Continuous Time (CT) PSoC blocks.
Table 11. DC Operational Amplifier Specifications
Symbol
V_OSOA
TCV_OSOA
I_EBOA
C_INOA
Description
Input Offset Voltage (absolute value) Low Power
Input Offset Voltage (absolute value) Mid Power
Input Offset Voltage (absolute value) High Power
Input Offset Voltage Drift
Input Leakage Current (Port 0 Analog Pins)
Input Capacitance (Port 0 Analog Pins)
Min
Typ
–
1.6
–
1.3
–
1.2
–
7.0
–
200
–
4.5
V_CMOA Common Mode Voltage Range
0.0
–
Common Mode Voltage Range (high power or high
opamp bias)
0.5
–
G_OLOA
V_OHIGHOA
V_OLOWOA
I_SOA
PSRR_OA
Open Loop Gain
High Output Voltage Swing (worst case internal load)
Power = Low
Power = Medium
Power = High
Low Output Voltage Swing (worst case internal load)
Power = Low
Power = Medium
Power = High
Supply Current (including associated AGND buffer)
Power = Low, Opamp Bias = Low
Power = Low, Opamp Bias = High
Power = Medium, Opamp Bias = Low
Power = Medium, Opamp Bias = High
Power = High, Opamp Bias = Low
Power = High, Opamp Bias = High
Supply Voltage Rejection Ratio
–
Vdd – 0.2
Vdd – 0.2
Vdd – 0.5
–
–
–
–
–
–
–
–
–
–
80
–
–
–
–
–
–
150
300
600
1200
2400
4600
80
Max
11
9
9
35.0
–
9.5
Vdd
Vdd –
0.5
–
–
–
–
0.2
0.2
0.5
200
400
800
1600
3200
6400
–
Units
Notes
mV
mV
mV
V/C
pA Gross tested to 1 A
pF Package and pin
dependent. Temp = 25 °C.
V The common-mode input
– voltage range is measured
through an analog output
buffer. The specification
includes the limitations
imposed by the
characteristics of the
analog output buffer.
dB
V
V
V
V
V
V
A
A
A
A
A
A
dB Vss VIN (Vdd - 2.25) or
(Vdd – 1.25 V) VIN  Vdd
Document Number: 38-12026 Rev. *N
Page 18 of 35