S6J328C Datasheet, PDF (15/179 Pages) Cypress Semiconductor – 32-bit Microcontroller Traveo Family

S6J3200 Series
Feature
Embedded
Program/Work Flash
Memory
Internal Power Domain
Power Supply
Low-voltage Detection
Low-voltage Detection for
RAM Retention (RVD)
Resource inter-connect
I/O Ports
A/D Converter
CRC
Programmable CRC
Sound Generator
Sound Waveform
Generator
Description
Embedded Program Flash can be accessed with 0-wait-cycle if CPU frequency is 80MHz or less.
0-wait-cycle: 80MHz or less.
1-wait-cycle: 160MHz or less.
2-wait-cycle: more than 160MHz.
The maximum frequency should be referred in datasheet.
Erase suspend is supported. Reading and writing to the other sector are possible when Flash
Erase is suspended.
Serial Flash programing and Parallel Flash programing are supported.
Margin mode is not supported.
PD1: Always ON
PD2: Cortex R5F platform/ GDC/ additional peripherals
PD4: Backup RAM in Always On domain
PD6: Peripherals in Always On domain
* The chapter of the block diagram explains in detail.
External 5V, 3V, 1.2V is required.
Built in LDO provides internal 1.2V for Always On region (PD1).
External 1.2V power supply control pin is supported.
External 3.3V power supply should be controlled by GPIO.
There are constraints of power on/off sequence.
LVD for external voltage is supported.
LVD for internal voltage is supported.
See the specification of the detected level on the datasheet.
RVD for RAM retention is effective during the standby mode only. That is, it is only for the Backup
RAM of 16KB that the function is available.
The output signal of some resources can be inputted to the other resource.
5V general purpose I/O
3V general purpose I/O
Multi input level and multi output drivability
Pull-up, pull-down function is available.
Resource input and output is multiplexed.
+B input is allowed many pins of 3.3V, 5V and 3.3V/5V I/O domain.
12bit resolution, 1 unit
50 channels of analog input for TEQFP256 and TEQPF216
46 channel of analog input for TEQFP208
24 channels of them are shared with the SMC for TEQFP256/216/208
External trigger and timer trigger are available.
The description of the A/D converter function should be referred in the S6J3200 hardware manual.
Though the chapter of I/O port in Traveo PF V3 hardware manual describes another A/D converter
function, do not refer it.
See the platform manual in detail.
DMA support
Produces sound/melody with varying frequency and amplitude for convenient duration
Square wave sound output
Automatic linear amplitude increment or decrement
Interrupt request generated when specified sound length has ended
Sine waveform, saw-tooth waveform and Square waveform are generated with easy configuration
of the parameters which specified sound sources.
Fade-in and Fade-out control for reverberation.
Document Number: 002-05682 Rev.*A
Page 15 of 179