S6E2G Datasheet, PDF (1/190 Pages) Cypress Semiconductor – 32-bit ARM® Cortex®-M4F FM4 Microcontroller

S6E2G Series
32-bit ARM^® Cortex^®-M4F
FM4 Microcontroller
S6E2G Series are FM4 devices with up to 180 MHz CPU, 1MB flash, 192KB SRAM, 20x communication peripherals, 33x digital
peripherals and 3x analog peripherals. They are designed for industrial automation and metering applications.
Devices in the S6E2G Series are highly integrated 32-bit microcontrollers with high performance and competitive cost. This series is
based on the ARM Cortex-M4F processor with on-chip flash memory and SRAM. The series has peripherals such as motor control
timers, A/D converters, and communications interfaces (USB, CAN, UART, CSIO (SPI), I2C, LIN). The products that are described
in this data sheet are placed into TYPE5-M4 product categories in the "FM4 Family Peripheral Manual Main Part (002-04856)”.
 32-bit ARM Cortex-M4F Core
− Up to 180 MHz frequency operation
 On-chip Memories
− Flash memory: Up to 1024 Kbytes
− SRAM memory:
 SRAM0: up to 128 Kbytes
 SRAM1: 32 Kbytes
 SRAM2: 32 Kbytes
 Direct Memory Access (DMA) Controller (Eight Channels)
 Descriptor System Data Transfer Controller (DSTC);
256 channels
 External Bus Interface
 USB Interface (Max two channels): Host and Device
 CAN Interface (Max one channel) Available on S6E2GM
and S6E2GH Devices Only
 Multi-function Serial Interface (Max 10 Channels)
− UART (Universal Asynchronous Receiver/Transmitter)
− Clock Synchronous Serial Interface (CSIO (SPI))
− Local Interconnect Network (LIN)
− Inter-Integrated Circuit (I²C)
− Inter-IC Sound (I²S)
 Base Timer (Max 16 channels)
 General Purpose I/O Port
− Up to 121 high-speed general-purpose I/O ports in
144-pin package
− Up to 153 high-speed general-purpose I/O ports in
176-pin package
 Multi-function Timer (Max two units)
 Real-Time Clock (RTC)
 Analog to Digital Converter (ADC) (Max 32 Channels)
Dual Timer (32-/16-bit Down Counter)
Quadrature Position/Revolution Counter (QPRC; Max four
channels)
 Watch Counter
 External Interrupt Controller Unit
 Watchdog Timer (Two channels)
 Cyclic Redundancy Check (CRC) Accelerator
 SD Card Interface Available on S6E2GM, S6E2GH, and
S6E2GK Devices Only
 Ethernet-MAC Available on S6E2GM, S6E2GK, and
S6E2G2 Devices only
 Smartcard Interface (Max 2 channels)
 Five Clock Sources
 Six Reset Sources
 Clock Supervisor (CSV)
 Low-Voltage Detector (LVD)
 Six Low-power Consumption Modes
− Sleep
− Timer
− RTC
− Stop
− Deep standby RTC
− Deep standby stop
 Peripheral Clock Gating System
 Crypto Assist Function
 Debug
− Serial wire JTAG debug port (SWJ-DP)
− Embedded trace macrocells (ETM) provide
comprehensive debug and trace facilities.
− AHB trace macrocells (HTM)
 41-bit Unique ID
 Wide range voltage: VCC = 2.7 to 5.5 V
Cypress Semiconductor Corporation
Document Number: 001-98708 Rev *B
• 198 Champion Court • San Jose, CA 95134-1709
Revised March 29, 2016
• 408-943-2600