CY7C68000A_09 Datasheet, PDF (1/15 Pages) Cypress Semiconductor – MoBL-USB TX2 USB 2.0 UTMI Transceiver

CY7C68000A
MoBL-USB™ TX2 USB 2.0 UTMI Transceiver
MoBL-USB™ TX2 Features
■ UTMI-Compliant and USB 2.0 Certified for Device Operation
■ Operates in Both USB 2.0 High Speed (HS), 480 Mbits/second,
and Full Speed (FS), 12 Mbits/second
■ Optimized for Seamless Interface with Intel^® Monahans Appli-
cations Processors
■ Tristate Mode Enables Sharing of UTMI Bus with other Devices
■ Serial-to-Parallel and Parallel-to-Serial Conversions
■ 8-bit Unidirectional, 8-bit Bidirectional, or 16-bit Bidirectional
External Data Interface
■ Synchronous Field and EOP Detection on Receive Packets
■ Synchronous Field and EOP Generation on Transmit Packets
■ Data and Clock Recovery from the USB Serial Stream
■ Bit Stuffing and Unstuffing; Bit Stuff Error Detection
■ Staging Register to Manage Data Rate Variation due to Bit
Stuffing and Unstuffing
■ 16-bit 30 MHz and 8-bit 60 MHz Parallel Interface
■ Ability to Switch between FS and HS Terminations and
Signaling
■ Supports Detection of USB Reset, Suspend, and Resume
■ Supports HS Identification and Detection as defined by the USB
2.0 Specification
Logic Block Diagram
■ Supports Transmission of Resume Signaling
■ 3.3V Operation
■ Two Package Options: 56-pin QFN and 56-pin VFBGA
■ All Required Terminations, Including 1.5 Kohm Pull Up on
DPLUS, are Internal to Chip
■ Supports USB 2.0 Test Modes
The Cypress MoBL-USB TX2 is a Universal Serial Bus (USB)
specification revision 2.0 transceiver, serial and deserializer, to a
parallel interface of either 16 bits at 30 MHz or eight bits at
60 MHz. The MoBL-USB TX2 provides a high speed physical
layer interface that operates at the maximum allowable USB 2.0
bandwidth. This enables the system designer to keep the
complex high speed analog USB components external to the
digital ASIC. This decreases development time and associated
risk. A standard USB 2.0-certified interface is provided and is
compliant with Transceiver Macrocell Interface (UTMI) specifi-
cation version 1.05 dated 3/29/2001.
This product is also optimized to seamlessly interface with
Monahans -P & -L applications processors. It has been charac-
terized by Intel and is recommended as the USB 2.0 UTMI trans-
ceiver of choice for its Monahans processors. It is also capable
of tristating the UTMI bus, while suspended, to enable the bus to
be shared with other devices.
Two packages are defined for the families: 56-pin QFN and
56-pin VFBGA.
The functional block diagram follows.
Tri_state
Cypress Semiconductor Corporation • 198 Champion Court
Document #: 38-08052 Rev. *H
• San Jose, CA 95134-1709 • 408-943-2600
Revised May 22, 2009
[+] Feedback