CY7C4282V_03 Datasheet, PDF (1/15 Pages) Cypress Semiconductor – 64K/128K x 9 Low-Voltage Deep Sync FIFOs with Retransmit and Depth Expansion

CY7C4282V
CY7C4292V
Features
64K/128K x 9 Low-Voltage Deep Sync FIFOs
with Retransmit and Depth Expansion
Functional Description
• 3.3V operation for low power consumption and easy
integration into low-voltage systems
• High-speed, low-power, first-in first-out (FIFO)
memories
• 64K × 9 (CY7C4282V)
• 128K × 9 (CY7C4292V)
• 0.35 micron CMOS for optimum speed/power
• High-speed, Near-Zero Latency (True Dual-Ported
Memory Cell), 100-MHz operation (10 ns read/write
cycle times)
• Low power
— I_CC = 25 mA
— I_SB = 6 mA
• Fully asynchronous and simultaneous read and write
operation
• Empty, Full, and Programmable Almost Empty and
Almost Full status flags
• Retransmit function
• Output Enable (OE) pin
• Independent read and write enable pins
• Supports free-running 50% duty cycle clock inputs
• Width Expansion Capability
• Depth Expansion Capability through token-passing
scheme (no external logic required)
• 64-pin 10 × 10 STQFP
• Pin-compatible 3.3V solution for CY7C4282/92
Logic Block Diagram
D_0–8
The CY7C4282V/92V are high-speed, low-power, FIFO
memories with clocked read and write interfaces. All devices
are nine bits wide. The CY7C4282V/92V can be cascaded to
increase FIFO depth. Programmable features include Almost
Full/Almost Empty flags. These FIFOs provide solutions for a
wide variety of data buffering needs, including high-speed data
acquisition, multiprocessor interfaces, video and communica-
tions buffering.
These FIFOs have 9-bit input and output ports that are
controlled by separate clock and enable signals. The input port
is controlled by a free-running clock (WCLK) and a Write
Enable pin (WEN).
Retransmit and Synchronous Almost Full/Almost Empty flag
features are available on these devices.
Depth expansion is possible using the Cascade Input (XI),
Cascade Output (XO), and First Load (FL) pins. The XO pin is
connected to the XI pin of the next device, and the XO pin of
the last device should be connected to the XI pin of the first
device. The FL pin of the first device is tied to VSS and the FL
pin of all the remaining devices should be tied to VCC
When WEN is asserted, data is written into the FIFO on the
rising edge of the WCLK signal. While WEN is held active, data
is continually written into the FIFO on each cycle. The output
port is controlled in a similar manner by a free-running Read
Clock (RCLK) and a Read Enable pin (REN). In addition, the
CY7C4282V/92V have an Output Enable pin (OE). The read
and write clocks may be tied together for single-clock
operation or the two clocks may be run independently for
asynchronous read/write applications. Clock frequencies up to
67 MHz are achievable.
INPUT
REGISTER
WCLK WEN
WRITE
CONTROL
WRITE
POINTER
RS
RESET
LOGIC
Dual Port
RAM Array
64K x 9
128K x 9
FLAG
PROGRAM
REGISTER
FLAG
LOGIC
READ
POINTER
FF
EF
PAE
PAF/XO
FL/RT
XI/LD
PAF/XO
EXPANSION
LOGIC
THREE-STATE
OUTPUT REGISTER
Q_{0 − 8}
OE
READ
CONTROL
RCLK REN
Cypress Semiconductor Corporation • 3901 North First Street • San Jose, CA 95134 • 408-943-2600
Document #: 38-06014 Rev. *B
Revised August 22, 2003