CY7C25632KV18 Datasheet, PDF (1/31 Pages) Cypress Semiconductor – 72-Mbit QDR® II+ SRAM Four-Word Burst Architecture (2.5 Cycle Read Latency) with ODT

CY7C25632KV18
CY7C25652KV18
72-Mbit QDR^® II+ SRAM Four-Word Burst Architecture
(2.5 Cycle Read Latency) with ODT
72-Mbit QDR® II+ SRAM Four-Word Burst Architecture (2.5 Cycle Read Latency) with ODT
Features
■ Separate independent read and write data ports
❐ Supports concurrent transactions
■ 550 MHz clock for high bandwidth
■ Four-word burst for reducing address bus frequency
■ Double data rate (DDR) interfaces on both read and write ports
(data transferred at 1100 MHz) at 550 MHz
■ Available in 2.5 clock cycle latency
■ Two input clocks (K and K) for precise DDR timing
❐ SRAM uses rising edges only
■ Echo clocks (CQ and CQ) simplify data capture in high-speed
systems
■ Data valid pin (QVLD) to indicate valid data on the output
■ On-die termination (ODT) feature
❐ Supported for D_[x:0], BWS_[x:0], and K/K inputs
■ Single multiplexed address input bus latches address inputs
for read and write ports
■ Separate port selects for depth expansion
■ Synchronous internally self-timed writes
■ QDR^® II+ operates with 2.5 cycle read latency when DOFF is
asserted HIGH
■ Operates similar to QDR I device with 1 cycle read latency when
DOFF is asserted LOW
■ Available in × 18, and × 36 configurations
■ Full data coherency, providing most current data
■ Core V_DD = 1.8 V ± 0.1 V; I/O V_DDQ = 1.4 V to V_DD ^[1]
❐ Supports both 1.5 V and 1.8 V I/O supply
■ HSTL inputs and variable drive HSTL output buffers
■ Available in 165-ball FBGA package (13 × 15 × 1.4 mm)
■ Offered in both Pb-free and non Pb-free packages
■ JTAG 1149.1 compatible test access port
■ Phase-locked loop (PLL) for accurate data placement
Configurations
With Read Cycle Latency of 2.5 cycles
CY7C25632KV18 – 4 M × 18
CY7C25652KV18 – 2 M × 36
Functional Description
The CY7C25632KV18 and CY7C25652KV18 are 1.8 V
Synchronous Pipelined SRAMs, equipped with QDR II+
architecture. Similar to QDR II architecture, QDR II+ architecture
consists of two separate ports: the read port and the write port to
access the memory array. The read port has dedicated data
outputs to support read operations and the write port has
dedicated data inputs to support write operations. QDR II+
architecture has separate data inputs and data outputs to
completely eliminate the need to “turn-around” the data bus that
exists with common I/O devices. Each port is accessed through
a common address bus. Addresses for read and write addresses
are latched on alternate rising edges of the input (K) clock.
Accesses to the QDR II+ read and write ports are completely
independent of one another. To maximize data throughput, both
read and write ports are equipped with DDR interfaces. Each
address location is associated with four 18-bit words
(CY7C25632KV18), or 36-bit words (CY7C25652KV18) that
burst sequentially into or out of the device. Because data is
transferred into and out of the device on every rising edge of both
input clocks (K and K), memory bandwidth is maximized while
simplifying system design by eliminating bus “turn-arounds”.
These devices have an On-Die Termination feature supported
for D_[x:0], BWS_[x:0], and K/K inputs, which helps eliminate
external termination resistors, reduce cost, reduce board area,
and simplify board routing.
Depth expansion is accomplished with port selects, which
enables each port to operate independently.
All synchronous inputs pass through input registers controlled by
the K or K input clocks. All data outputs pass through output
registers controlled by the K or K input clocks. Writes are
conducted with on-chip synchronous self-timed write circuitry.
Selection Guide
Description
Maximum Operating Frequency
Maximum Operating Current
× 18
× 36
550 MHz
550
920
1310
500 MHz
500
850
1210
450 MHz
450
780
1100
400 MHz
400
710
1000
Unit
MHz
mA
Note
1. The Cypress QDR II+ devices surpass the QDR consortium specification and can support V_DDQ = 1.4 V to V_DD.
Cypress Semiconductor Corporation • 198 Champion Court
Document Number: 001-66482 Rev. *C
• San Jose, CA 95134-1709 • 408-943-2600
Revised September 21, 2012