CY7C1353F Datasheet, PDF (1/13 Pages) Cypress Semiconductor – 4-Mb (256K x 18) Flow-through SRAM with NoBL Architecture

CY7C1353F
4-Mb (256K x 18) Flow-through SRAM with NoBL™ Architecture
Features
• Can support up to 133-MHz bus operations with zero
wait states
— Data is transferred on every clock
• Pin compatible and functionally equivalent to ZBT™
devices
• Internally self-timed output buffer control to eliminate
the need to use OE
• Registered inputs for flow-through operation
• Byte Write capability
• 256K x 18 common I/O architecture
• 2.5V / 3.3V I/O power supply
• Fast clock-to-output times
— 6.5 ns (for 133-MHz device)
— 7.5 ns (for 117-MHz device)
— 8.0 ns (for 100-MHz device)
— 11.0 ns (for 66-MHz device)
• Clock Enable (CEN) pin to suspend operation
• Synchronous self-timed writes
• Asynchronous Output Enable
• JEDEC-standard 100 TQFP package
Logic Block Diagram
• Burst Capability—linear or interleaved burst order
• Low standby power
Functional Description^[1]
The CY7C1353F is a 3.3V, 256K x 18 Synchronous
Flow-through Burst SRAM designed specifically to support
unlimited true back-to-back Read/Write operations without the
insertion of wait states. The CY7C1353F is equipped with the
advanced No Bus Latency™ (NoBL™) logic required to
enable consecutive Read/Write operations with data being
transferred on every clock cycle. This feature dramatically
improves the throughput of data through the SRAM, especially
in systems that require frequent Write-Read transitions.
All synchronous inputs pass through input registers controlled
by the rising edge of the clock. The clock input is qualified by
the Clock Enable (CEN) signal, which when deasserted
suspends operation and extends the previous clock cycle.
Maximum access delay from the clock rise is 6.5 ns (133-MHz
device).
Write operations are controlled by the two Byte Write Select
(BW_[A:B]) and a Write Enable (WE) input. All writes are
conducted with on-chip synchronous self-timed write circuitry.
Three synchronous Chip Enables (CE₁, CE₂, CE₃) and an
asynchronous Output Enable (OE) provide for easy bank
selection and output three-state control. In order to avoid bus
contention, the output drivers are synchronously three-stated
during the data portion of a write sequence.
A0, A1, A
MODE
CLK
C
CE
CEN
ADV/LD
BWA
BWB
WE
ADDRESS
REGISTER
A1
A0
D1
D0
ADV/LD
C
WRITE ADDRESS
REGISTER
Q1
Q0
A1'
A0'
BURST
LOGIC
WRITE REGISTRY
AND DATA COHERENCY
CONTROL LOGIC
S
E
N
MEMORY
S
WRITE
ARRAY
E
DRIVERS
A
M
P
S
O
U
T
D
P
A
U
T
T
A
B
S
U
T
F
E
F
E
E
R
R
I
S
N
E
G
DQs
DQPA
DQPB
OE
CE1
CE2
CE3
ZZ
1
READ LOGIC
SLEEP
CONTROL
INPUT _E
REGISTER
Note:
1. For best–practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Cypress Semiconductor Corporation • 3901 North First Street • San Jose, CA 95134 • 408-943-2600
Document #: 38-05212 Rev. *B
Revised January 13, 2004