CY7C1223F Datasheet, PDF (1/15 Pages) Cypress Semiconductor – 2-Mb (128K x 18) Pipelined DCD Sync SRAM

CY7C1223F
2-Mb (128K x 18) Pipelined DCD Sync SRAM
Features
Functional Description^[1]
• Registered inputs and outputs for pipelined operation
• Optimal for performance (Double-Cycle deselect)
— Depth expansion without wait state
• 128K × 18-bit common I/O architecture
• 3.3V –5% and +10% core power supply (V_DD)
• 3.3V I/O supply (V_DDQ)
• Fast clock-to-output time
— 3.5 ns (for 166-MHz device)
— 4.0 ns (for 133-MHz device)
• Provide high-performance 3-1-1-1 access rate
• User-selectable burst counter supporting Intel^
Pentium^ interleaved or linear burst sequences
• Separate processor and controller address strobes
• Synchronous self-timed writes
• Asynchronous Output Enable
• JEDEC-standard 100-pin TQFP package and pinout
• “ZZ” Sleep Mode option
The CY7C1223F SRAM integrates 131,072 x 18 SRAM cells
with advanced synchronous peripheral circuitry and a two-bit
counter for internal burst operation. All synchronous inputs are
gated by registers controlled by a positive-edge-triggered
Clock Input (CLK). The synchronous inputs include all
addresses, all data inputs, address-pipelining Chip Enable
(CE₁), depth-expansion Chip Enables (CE₂ and CE₃), Burst
Control inputs (ADSC, ADSP, and ADV), Write Enables
(BW_[A:B] and BWE), and Global Write (GW). Asynchronous
inputs include the Output Enable (OE) and the ZZ pin.
Addresses and chip enables are registered at rising edge of
clock when either Address Strobe Processor (ADSP) or
Address Strobe Controller (ADSC) are active. Subsequent
burst addresses can be internally generated as controlled by
the Advance pin (ADV).
Address, data inputs, and write controls are registered on-chip
to initiate a self-timed Write cycle.This part supports Byte Write
operations (see Pin Descriptions and Truth Table for further
details). Write cycles can be one to two bytes wide as
controlled by the byte write control inputs. GW active LOW
causes all bytes to be written. This device incorporates an
additional pipelined enable register which delays turning off
the output buffers an additional cycle when a deselect is
executed.This feature allows depth expansion without penal-
izing system performance.
The CY7C1223F operates from a +3.3V core power supply
while all outputs operate with a +3.3V supply. All inputs and
outputs are JEDEC-standard JESD8-5-compatible.
Selection Guide
166 MHz 133 MHz
Maximum Access Time
3.5
4.0
Maximum Operating Current
240
225
Maximum CMOS Standby Current
40
40
Shaded areas contain advance information. Please contact your local Cypress sales representative for availability of this part.
Note:
1. . For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Unit
ns
mA
mA
Cypress Semiconductor Corporation • 3901 North First Street • San Jose, CA 95134 • 408-943-2600
Document #: 38-05418 Rev. *A
Revised April 10, 2004