CY7C1217H Datasheet, PDF (1/16 Pages) Cypress Semiconductor – 1-Mbit (32K x 36) Flow-Through Sync SRAM

CY7C1217H
1-Mbit (32K x 36) Flow-Through Sync SRAM
Features
• 32K x 36 common I/O
• 3.3V core power supply (V_DD)
• 2.5V/3.3V I/O power supply (V_DDQ)
• Fast clock-to-output times
— 6.5 ns (for 133-MHz version)
• Provide high-performance 2-1-1-1 access rate
• User-selectable burst counter supporting Intel^®
Pentium^® interleaved or linear burst sequences
• Separate processor and controller address strobes
• Synchronous self-timed write
• Asynchronous output enable
• Available in JEDEC-standard lead-free 100-Pin TQFP
package
• “ZZ” Sleep Mode option
Selection Guide
Maximum Access Time
Maximum Operating Current
Maximum Standby Current
Functional Description^[1]
The CY7C1217H is a 32K x 36 synchronous cache RAM
designed to interface with high-speed microprocessors with
minimum glue logic. Maximum access delay from clock rise is
6.5 ns (133-MHz version). A 2-bit on-chip counter captures the
first address in a burst and increments the address automati-
cally for the rest of the burst access. All synchronous inputs
are gated by registers controlled by a positive-edge-triggered
Clock Input (CLK). The synchronous inputs include all
addresses, all data inputs, address-pipelining Chip Enable
(CE₁), depth-expansion Chip Enables (CE₂ and CE₃), Burst
Control inputs (ADSC, ADSP, and ADV), Write Enables
(BW_[A:D], and BWE), and Global Write (GW). Asynchronous
inputs include the Output Enable (OE) and the ZZ pin.
The CY7C1217H allows either interleaved or linear burst
sequences, selected by the MODE input pin. A HIGH selects
an interleaved burst sequence, while a LOW selects a linear
burst sequence. Burst accesses can be initiated with the
Processor Address Strobe (ADSP) or the cache Controller
Address Strobe (ADSC) inputs. Address advancement is
controlled by the Address Advancement (ADV) input.
Addresses and chip enables are registered at rising edge of
clock when either Address Strobe Processor (ADSP) or
Address Strobe Controller (ADSC) are active. Subsequent
burst addresses can be internally generated as controlled by
the Advance pin (ADV).
The CY7C1217H operates from a +3.3V core power supply
while all outputs may operate either with a +2.5V or +3.3V
supply. All inputs and outputs are JEDEC-standard
JESD8-5-compatible.
133 MHz
6.5
225
40
100 MHz
Unit
8.0
ns
205
mA
40
mA
Note:
1. For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Cypress Semiconductor Corporation • 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600
Document #: 38-05670 Rev. *B
Revised July 6, 2006
[+] Feedback