CY62127DV30_06 Datasheet, PDF (1/11 Pages) Cypress Semiconductor – 1-Mb (64K x 16) Static RAM

CY62127DV30
1-Mb (64K x 16) Static RAM
Features
• Temperature Ranges
— Industrial: –40°C to 85°C
— Automotive: –40°C to 125°C
• Very high speed: 45 ns
• Wide voltage range: 2.2V to 3.6V
• Pin compatible with CY62127BV
• Ultra-low active power
— Typical active current: 0.85 mA @ f = 1 MHz
— Typical active current: 5 mA @ f = f_MAX
• Ultra-low standby power
• Easy memory expansion with CE and OE features
• Automatic power-down when deselected
• Available in Pb-Free and non Pb-Free 48-ball FBGA and
a 44-lead TSOP Type II packages
Functional Description^[1]
The CY62127DV30 is a high-performance CMOS static RAM
organized as 64K words by 16 bits. This device features
advanced circuit design to provide ultra-low active current.
This is ideal for providing More Battery Life™ (MoBL^®) in
Logic Block Diagram
portable applications such as cellular telephones. The device
also has an automatic power-down feature that significantly
reduces power consumption by 90% when addresses are not
toggling. The device can be put into standby mode reducing
power consumption by more than 99% when deselected (CE
HIGH or both BHE and BLE are HIGH). The input/output pins
(I/O₀ through I/O₁₅) are placed in a high-impedance state
when: deselected (CE HIGH), outputs are disabled (OE
HIGH), both Byte High Enable and Byte Low Enable are
disabled (BHE, BLE HIGH) or during a write operation (CE
LOW and WE LOW).
Writing to the device is accomplished by taking Chip Enable
(CE) and Write Enable (WE) inputs LOW. If Byte Low Enable
(BLE) is LOW, then data from I/O pins (I/O₀ through I/O₇), is
written into the location specified on the address pins (A₀
through A₁₅). If Byte High Enable (BHE) is LOW, then data
from I/O pins (I/O₈ through I/O₁₅) is written into the location
specified on the address pins (A₀ through A₁₅).
Reading from the device is accomplished by taking Chip
Enable (CE) and Output Enable (OE) LOW while forcing the
Write Enable (WE) HIGH. If Byte Low Enable (BLE) is LOW,
then data from the memory location specified by the address
pins will appear on I/O₀ to I/O₇. If Byte High Enable (BHE) is
LOW, then data from memory will appear on I/O₈ to I/O₁₅. See
the truth table at the back of this data sheet for a complete
description of read and write modes
.
DATA IN DRIVERS
A₁₀ 10
A₉
A₈
A₇
A₆
A₅
64K x 16
A₄
RAM Array
A₃
2048 x 512
A₂
A₁
A₀
I/O₀–I/O₇
I/O₈–I/O₁₅
COLUMN DECODER
Power -Down
Circuit
CE
BHE
BLE
BHE
WE
CE
OE
BLE
Note:
1. For best-practice recommendations, please refer to the Cypress application note “System Design Guidelines” on http://www.cypress.com.
Cypress Semiconductor Corporation • 198 Champion Court • San Jose, CA 95134-1709 • 408-943-2600
Document #: 38-05229 Rev. *H
Revised June 19, 2006
[+] Feedback