CY23S05 Datasheet, PDF (1/9 Pages) Cypress Semiconductor – Low Cost 3.3V Spread Aware Zero Delay Buffer

CY23S09, CY23S05
Low Cost 3.3V Spread Aware
Zero Delay Buffer
Features
■ 10 MHz to 100 and 133 MHz operating range, compatible
with CPU and PCI bus frequencies
■ Zero input-output propagation delay
■ Multiple low skew outputs
❐ Output-output skew less than 250 ps
❐ Device-device skew less than 700 ps
❐ One input drives five outputs (CY23S05)
❐ One input drives nine outputs, grouped as 4 + 4 + 1
(CY23S09)
■ Less than 200 ps cycle-to-cycle jitter is compatible with
Pentium^® based systems
■ Test mode to bypass PLL (CY23S09 only, see Select Input
Decoding for CY23S09 on page 2)
■ Available in space saving 16-pin, 150-mil SOIC, 4.4 mm
TSSOP, and 150-mil SSOP ( CY23S09) or 8-pin, 150-mil
SOIC package (CY23S05)
■ 3.3V operation, advanced 0.65μ CMOS technology
■ Spread Aware
Functional Description
The CY23S09 is a low cost 3.3V zero delay buffer designed to
distribute high speed clocks and is available in a 16-pin SOIC
package. The CY23S05 is an 8-pin version of the CY23S09. It
accepts one reference input, and drives out five low skew clocks.
The -1H versions of each device operate at up to 100 and 133
Logic Block Diagram
MHz frequencies and have higher drive than the -1 devices. All
parts have on-chip PLLs that lock to an input clock on the REF
pin. The PLL feedback is on-chip and is obtained from the
CLKOUT pad.
The CY23S09 has two banks of four outputs each, which can be
controlled by the select inputs as shown in the Select Input
Decoding table on Select Input Decoding for CY23S09 on page
2. If all output clocks are not required, Bank B can be
three-stated. The select inputs also allow the input clock to be
directly applied to the outputs for chip and system testing
purposes.
The CY23S09 and CY23S05 PLLs enter a power down mode
when there are no rising edges on the REF input. In this state,
the outputs are three-stated and the PLL is turned off, resulting
in less than 12.0 μA of current draw (for commercial temperature
devices) and 25.0 μA (for industrial temperature devices). The
CY23S09 PLL shuts down in one additional case, as shown in
the Select Input Decoding for CY23S09 on page 2.
Multiple CY23S09 and CY23S05 devices can accept the same
input clock and distribute it. In this case, the skew between the
outputs of two devices is guaranteed to be less than 700 ps.
All outputs have less than 200 ps of cycle-to-cycle jitter. The input
to output propagation delay on both devices is guaranteed to be
less than 350 ps; the output to output skew is guaranteed to be
less than 250 ps.
The CY23S05 and CY23S09 is available in two different config-
urations, as shown in the Ordering Information on page 6. The
CY23S05-1 and CY23S09-1 is the base part. The CY23S05-1H
and CY23S09-1H is the high drive version of the -1, and its rise
and fall times are much faster than -1.
Cypress Semiconductor Corporation • 198 Champion Court
Document Number: 38-07296 Rev. *D
• San Jose, CA 95134-1709 • 408-943-2600
Revised October 22, 2008
[+] Feedback