MP1C Datasheet, PDF (1/2 Pages) Cynergy3 Co – the switch stops the compressor and starts the pump

MP1C Series
This float switch is designed specially to maintain the air cushion in autoclaves
and is available in two different versions 1” or 1”1/4.diameter.
Thanks to its small diameter it can be introduced into the tank through a coupling
and mounted either horizontally or vertically (with counterweight).The level switch
action point is determined by the cable length with the entry point (if horizontal) or
to the application point (if vertical).When the tank water level rises , the switch
gives the starting up command to the compressor contactor or to the compressed
air valve, which then stops the pump with an auxiliary contact.
When the water / air level stabilises at the desired position, the switch stops the
compressor and starts the pump.
Technical Specifications
Contact Form
Material
Temp Range
°C
°F
Cable
Standard cable covering
Max. working pressure
Electrical Specifications
Power Rating
Max
Switching Voltage Max
Switching Current Max. Resistive
MP1C-3
MP1C-5
C/O
High Density Polyethylene
0 / +55
+ 32 / +131
3 metre
5 metre
PVC 3x1 A05 VVF Rf60
10 bar
3VA
60Vac
0.25 A
It is necessary to use an auxiliary relay, when switching any significant load.
MECHANICAL
• For compressor receivers
or pressurised tanks
• Installation through G1”or
G1”1/4
• Supplied with gland &
counterweight
• Mount through side or top
of tank
Off - On
Differential 5%
On - Off
Minimum Cable Pivot
length 120mm
Cynergy3 Components Ltd
7 Cobham Road
Ferndown Industrial Estate
Wimborne
Dorset BH21 7PE
Tel: [phone]
[e-mail]
ISO 9001C ER TI FIED
www.cynergy3.com
© 2011 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.