FSVPLC Datasheet, PDF (1/2 Pages) Cynergy3 Co – Inline Flow Switch for connection to PLC

FSVPLC
Inline Flow Switch for connection to PLC
Signal level output for PLC
0.6 l/min or 3.0 l/min turn on flow rate
Automatic shut down on flow stop
Volt free contact for output to PLC
1”BSP pipe connections
Technical Specification
Flow Tube Material
Start up flow rate
Q. min
l/min
Max flow rate
Q max
l/min
Max Pressure
P max
bar
Max Temperature
T max
°C
Pipe connections
BSP
FSVPLC06
0.6
Brass
80
8
85
1”
FSVPLC30
3.0
Electrical Specification
Output
Max voltage
Switching Current Max
SPNC volt free contact
Vac
<5
mA
<1
The FSVPLC can be used to control some
other equipment or process via a PLC. If
used in a pumped system, the device has
to be fitted in the pipe above the pump.
The FSVPLC gives an open circuit signal to
the PLC once the flow rate through the
device exceeds 0.6 l/min, or 3 l/min
depending on version.
Standard Parts
FSVPLC06
FSVPLC30
90
82
On flow rate
0.6l/min
3.0 l/min
A flow of less than 0.6 l/min , or 3.0 l/min
depending on version, whether due to a
lack of supply (e.g. tank empty) or to a
decrease in demand(e.g. tap closing), will
turn the signal to the control circuit on
again.
Cynergy3 Components Ltd.
7 Cobham Road
Ferndown Industrial Estate
Wimborne, Dorset BH21 7PE
Telephone [phone]
Email:[e-mail]
ISO9001 C E R T I F I E D
www.cynergy3.com
© 2014 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.