FSHPLC Datasheet, PDF (1/2 Pages) Cynergy3 Co – Flow switch for connection to PLC

FSHPLC
Flow switch for connection to PLC
Signal level output for PLC
20 l/min turn on flow rate
Automatic shut down on flow stop
Volt free contact for output to PLC
1”BSP pipe connections
Technical Specification
Screw mount Material
Enclosure material
Enclosure rating
Start up flow rate
Q. min
l/min
Max Pressure
P max
bar
Max Temperature
T max
°C
Pipe connections
BSP
Brass
Polyamide
IP54
20
10
100
1”
Electrical Specification
Output
Max voltage
Switching Current Max
SPNO volt free contact
Vac
<5
mA
<1
Standard Parts
FSH10PLC
The FSHPLC can be used to control some
other equipment or process via a PLC.
It could be for controlling a circulating or
centrifugal electric pump that is providing
increased pressure or flow within water
systems with storage tanks.
The FSHPLC switches the output, once the
flow rate through the pipe exceeds 20
l/min.
A flow of less than 20 l/min, whether due
to a lack of supply (e.g. tank empty) or to a
decrease in demand(e.g. tap closing), will
turn the output off again.
94
22
On flow rate
20 l/min
95
113
Cynergy3 Components Ltd.
7 Cobham Road
Ferndown Industrial Estate
Wimborne, Dorset BH21 7PE
Telephone [phone]
Email:[e-mail]
ISO9001 C E R T I F I E D
www.cynergy3.com
© 2014 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.