FCTE Datasheet, PDF (1/2 Pages) Cynergy3 Co – Pump Dry Running Sensor

FCTE
Pump Dry Running Sensor
The FCTE is a heat sensor, which is attached to the outlet pipe from a pump. This
device works by reacting to the temperature at the outlet of any centrifugal type pump,
which will rapidly rise past 45 ° if the inlet water level falls below the centre line of the
inlet. The unit will cut off the electrical supply to the pump, so protecting it from
damage. Manual resetting of this unit allows the pump to restart.
SPECIFICATION
Set Temperature
Switching voltage max.
Switching current max. resistive
Pipe diameter range
IP Rating
45°C 113°F
250Vac
16A
20-200mm
21
cyn er gy_{componen ts}
TE thermostat
Heat accumulation
zone due to vapour
formation
Level of
water when
TE cuts in
TE thermostat also
protects the seal
TE
• Prevents dry-running
of pump
• Prevents overheating
of seals
• High power switching
capacity
Dia. _{min 20 max 400}
Spring clip fixing sensor to pipe
Cynergy3 Components Ltd
7 Cobham Road
Ferndown Industrial Estate
Wimborne
Dorset BH21 7PE
Tel: [phone]
[e-mail]
ISO 9001C ER TI FIED
www.cynergy3.com
© 2013 Cynergy3 Components, All Rights Reserved. Specifications are subject to change without prior notice. Cynergy3 Components and the Cynergy3 Components logo are trademarks of Cynergy3 Components Limited.
FCTE 2013