|
CWR-130-14-0000 Datasheet, PDF (1/4 Pages) CW Industries – DIP Connectors | |||
|
DIP Connectors
The CW Dual-In-Line Plug (DIP) connector is used for rapid, permanent connection
of ribbon cable to a PC board or to a standard DIP socket when connect/disconnect
capabilities are required. The cover is factory preassembled to the connector base to
simplify assembly to cable and has ridges for cable alignment. CW DIP connectors
are Mil-DTL-83503/6 approved.
⢠Beveled corner on cover and base
at pin #1 provides orientation and
contact identification.
⢠No alignment tools required.
Cable fits snugly between baseâs
cover-support posts, and is guided
into position by ridges molded into
inner surface of cover.
⢠No special cable preparation
required. Factory preassembled
cover minimizes assembly time.
Cable is inserted and terminated in
one simple step.
⢠Sturdy terminal posts are strong,
yet flexible enough to withstand
occasional bending and
straightening without fatigue.
⢠No âbare shouldersâ. No exposure
of unnecessary sections of the
contact and possible shorting at the
PC board interface.
30
⢠130 James Way, Southampton, PA 18966 - 3838 ⢠Telephone: (215) 355-7080 ⢠Fax: (215) 355-1088 ⢠www.cwind.com
|
▷ |