|
VAT2-SMT_12 Datasheet, PDF (4/5 Pages) CUI INC – DC-DC CONVERTER | |||
|
◁ |
CUI Inc â SERIES: VAT2-SMT â DESCRIPTION: DC-DC CONVERTER
date 11/01/2012 â page 4 of 5
APPLICATION NOTES
1. Requirement on Output Load
In order to ensure the product operates efï¬ciently and reliably, make sure the speciï¬ed range of input voltage is not exceeded and the
minimum output load is not less than 10% load. If the actual load is less than the speciï¬ed minimum load, the output ripple may
increase sharply while its efï¬ciency and reliability will reduce greatly. If the actual output power is very small, please add an
appropriate resistor as extra loading.
2. Overload Protection
Under normal operating conditions, the output circuit of these products has no protection against over-current and short-circuits. The
simplest method is to connect a self-recovery fuse in series at the input end or add a circuit breaker to the circuit.
3. Filtering
In some circuits which are sensitive to noise and ripple, a ï¬ltering capacitor may be added to the DC/DC output end and input end to
reduce the noise and ripple. However, the capacitance of the output ï¬lter capacitor must be proper. If the capacitance is too big, a
startup problem might arise. For every channel of output, provided the safe and reliable operation is ensured, the greatest
capacitance of its ï¬lter capacitor sees the external capacitor table. To get an extremely low ripple, an âLCâ ï¬ltering network may be
connected to the input and output ends of the DC/DC converter, which may produce a more signiï¬cant ï¬ltering effect. It should also
be noted that the inductance and the frequency of the âLCâ ï¬ltering network should be staggered with the DC/DC frequency to avoid
mutual interference (Figure 1).
Figure 1
4. Output Voltage Regulation and Over-voltage Protection Circuit
The simplest device for output voltage regulation, over-voltage and over-current protection is a linear voltage regulator with overheat
protection that is connected to the input or output end in series (Figure 2).
Figure 2
5. External Capacitor Table
It is not recommended to connect any external capacitor in the application ï¬eld with less than 0.5 W output.
Table 1
Vin
(Vdc)
5
12
--
--
Cin
(μF)
4.7
2.2
--
--
Vout
(Vdc)
±5
±9
±12
±15
Cout
(μF)
4.7
2.2
1
0.47
cui.com
|
▷ |