English
Language : 

CCV-084B16 Datasheet, PDF (3/5 Pages) CUI INC – magnetic buzzer
PART NUMBER: CCV-084B16
DESCRIPTION: magnetic buzzer
page 3 of 5
date 3/6/2008
MECHANICAL CHARACTERISTICS
item
test condition
evaluation standard
solderability
Lead terminals are immersed in solder bath 95% min. of the lead terminals
of 270 ±5°C for 3 ±1 seconds.
will be wet with solder.
soldering heat resistance
The product is followed the reflow temperature No interference in operation.
curve to test its reflow thermo stability.
terminal mechanical strength
Lead pads shall be soldered on the pc board,
and a force of 9.8N (1.0kg) shall be applied No damage or cutting off.
behind the part for 10 seconds.
vibration
The buzzer shall be measured after applying The value of oscillation
a vibration amplitude of 1.5 mm with 10 to
frequency/current consumption
55 Hz band of vibration frequency to each of should be ±10% of the initial
the 3 perpendicular directions for 2 hours.
measurements. The SPL should
drop test
The part will be dropped from a height of
be within ±10dB compared with
75 cm onto a 40 mm thick wooden board 3
the initial measurement.
times in 3 axes (X, Y, Z) for a total of 9 drops.
ENVIRONMENT TEST
item
high temp. test
low temp. test
thermal shock
temp. cycle test
test condition
After being placed in a chamber at +85°C for
96 hours.
After being placed in a chamber at -40°C for
96 hours.
The part shall be subjected to 10 cycles. One
cycle will consist of:
evaluation standard
The part shall be subjected to 5 cycles. One
cycle will consist of:
The buzzer will be measured after
being placed at +25°C for 4
hours. The value of the
oscillation frequency/current
consumption should be ±10%
compared to the initial
measurements. The SPL should
be within ±10dB compared to the
initial measurements.
20050 SW 112th Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2383