CCG-1206 Datasheet, PDF (3/4 Pages) CUI INC – magnetic buzzer

Part No: CCG-1206
Description: magnetic buzzer
Date: 3/19/2007
Unit: mm
Page No: 3 of 4
Mechanical Characteristics
Item
Solderability
Soldering Heat Resistance
Terminal Mechanical Strength
Vibration
Drop Test
Test Condition
Evaluation Standard
Lead terminals are immersed in a solder bath 90% min. of lead terminals should
of +270 ±5°C for 3 ±1 seconds.
be covered with fresh solder.
(Except the edge of the terminal.)
Lead terminals are immersed in solder bath No in interference in operation.
of +260 ±5°C for 3 ±1 seconds.
The force of 9.8N (1.0kg) should be applied to No damage or cutting off.
each terminal in each axial direction.
The buzzer will be measured after applying
After the test, the part should
a vibration amplitude of 1.5 mm with 10 to
meet specifications without any
55 Hz band of vibration frequency to each of damage to the appearance and
the 3 perpendicular directions for 2 hours
the SPL should be within
The part should be dropped from a height of ±10 dBA of the initial
75 cm onto a 40 mm thick wooden board 3
measurement.
times in 3 axis (X, Y, Z) for a total of 9 drops.
Environment Test
Item
High temp. test
Low temp. test
Thermal shock
Test Condition
The part will be subjected to +85°C for
96 hours.
The part will be subjected to -40°C for
96 hours
The part will be subjected to 10 cycles. One
cycle will consist of:
Evaluation Standard
Temp./Humidity cycle
The part shall be subjected to 10 cycles. One
cycle should last 24 hours and will consist of:
After the test, the part should
meet specifications without any
damage to the appearance or
performance except SPL. After 4
hours at 25°C, the SPL should be
within ±10 dBA of the initial
measurement.
Phone: [phone] Fax: [phone] www.cui.com 20050 SW 112th Ave. Tualatin, OR 97062