767163203GP Datasheet, PDF (3/4 Pages) CTS Corporation – Surface Mount Resistor Network

PACKAGING INFORMATION
Tape & Reel
14 Pin
Tape Width
24mm
Tape Pitch
12mm
Reel Diameter
No. Parts/Reel
13"
2,000
16 Pin
24mm
12mm
13"
2,000
Series 767
Surface Mount Resistor Network
Slide Packs
Tube Length
No. Parts/Slide Pack
14 Pin
20"
48
16 Pin
20"
43
ELECTRICAL & ENVIRONMENTAL CHARACTERISTICS
GENERAL REQUIREMENTS
Resistance Range:
Standard: 10 Ohms to 1M Ohms
Operating Temperature Range:
-55°C to +125°C
Temperature Coefficient:
10 Ohms to 99 Ohms - ±200ppm/°C typical
100 Ohms to 1M Ohms - ±100ppm/°C typical
Resistance Tolerance:
Standard: ±2% or 0.5 Ohms [whichever is greater]
Special: ±0.25% or 0.3 Ohms [whichever is greater]
Dielectric Strength:
100 V_AC
Maximum Operating Voltage:
50 V, not to exceed rated power
POWER RATING
[Total Network Power]
Temperature 14 Pin
@25°C
2.0W
@70°C
1.3W
16 Pin
2.3W
1.5W
MAXIMUM RESISTOR POWER
[Not to exceed total network power]
Schematic
1
3
@25°C
0.15W 0.30W
@70°C
0.10W 0.20W
5
0.15W
0.10W
7
0.15W
0.10W
CIRCUIT TYPES
BUSSED [Schematic 1]
ISOLATED [Schematic 3]
DUAL TERMINATOR [Schematic 5]
R/2R LADDER [Schematic 7]
ENVIRONMENTAL
TEST
Temperature Cycling
Short Time Overload
Moisture Resistance
Load Humidity
High Temperature Exposure
Load Life
Resistance to Solder Heat
Mechanical Shock
Vibration
Terminal Strength
Low Temperature Storage
Low Temperature Operation
Flammability
Non-Fungus
Resistance to Solvents
Solderability
MAXIMUM %
DELTA R
0.25%
0.25%
0.50%
1.00%
1.00%
1.00%
0.25%
0.25%
0.25%
0.25%
0.25%
0.25%
N/A
Pass
Pass
Pass
MIL-STD 202
METHOD
107
106
108
213
204
TEST CONDITION/DESCRIPTION
Condition B; 5 cycles, -65°C to +125°C
2 1/2 times rated voltage, 5 seconds [100V maximum]
240 hours, -10°C to +65°C, 90% RH, 0.1 rated load
1000 hours, +70°C, 85-92% RH, 0.1 rated load
240 hours @ +125°C, no load
Condition F; 2000 hours @ +70°C, rated load
30 seconds @ +218°C, dwell
Condition I; 100g, 1m second, 3 shocks each plane
Condition D; 20g, 10-2000Hz, 4 hours/plane
24 hours @ -65°C, no load
45 minutes @ -65°C, no load
94V-0
20g, 10-2000Hz, 4 hours/plane
MIL-STD 810C
Isopropyl alcohol
RMA Flux, +230°C, 5 seconds dip, 95% coverage
Document No. 008-0349-0
Page 3 - 4
Rev. C