442TA2T103BDN Datasheet, PDF (1/2 Pages) CTS Corporation – Commercial Linear Motion Carbon Composition Slide Potentiometer

Series 442 Data Sheet
Slide Potentiometer
Commercial
Linear Motion
Carbon Composition
Slide Potentiometer
Features
• 1¹/4" (31.7mm) travel
• ¹/4 watt power rating
• Choice of resistance tapers
• Economical
• Wide resistance range
• Choice of mounting styles
• RoHS compliant
Electrical and Mechanical Specifications
Resistance Range
200 ohms through 5 Megohms, linear
Consult CTS for audio taper
Resistance Tolerance
±30%, ±20%, ±10%
Power Rating, Watts
1_{/4 watt @ 55°C derated to no load @ 85°C,}
linear taper, control mounted on steel panel
4" x 4" x .050" (101.6mm x 101.6mm x 1.27mm).
Voltage Rating
Across end terminals:
Linear curves — 500 VDC
Tapered curves — 350 VDC
(Not to exceed wattage ratings)
Between case and end terminals:
1080 VAC RMS
Resistance Tapers
Standard: Linear
Special: Available upon request
Operating Temperature
0°C to +70°C
Actuator Travel
1¹/4 inches (31.7mm)
Potentiometer Life
10,000 cycles
Actuator Information
See illustrations, page 2.
Operating Force
Either direction 1 to 9 oz. (28 to 256 g )
Measured .250" (6.35mm) from base of actuator
Stop Strength
Maximum — 35 lbs. (15.9 kg) measured
at base of actuator
Terminal Information
Straight, vertical or snap-in to printed circuit board,
wirewrap or solder lug styles.
Mounting Information
Top, bottom, side twist tab or no twist tab mounting —
refer to illustrations, page 2.
1-2
CTS Electrocomponents
© 2016 CTS Corporation. All rights reserved. Information subject to change.
01/12/16
www.ctscorp.com