|
270 Datasheet, PDF (1/6 Pages) CTS Corporation – Commercial Miniature 5/8 (16mm) Diameter Composition Variable Resistors | |||
|
Series 270
®
Commercial
Miniature 5/8"
(16mm) Diameter
Composition
Variable Resistors
⢠Miniature 5/8" (16mm) size
⢠Versatile mounting styles:
â bushing
â twist tab
â bend tab
â snap-in PC bracket
â solder lug or PC terminals
(shaft parallel or perpendicular to the panel)
⢠100 ⦠to 5 Meg ⦠resistance range
⢠Molded or metal shafts
⢠SPST power switches
⢠Single, tandem, or concentric units
⢠Panel seal
⢠Rear extended shaft
Electrical and Mechanical Specifications
Resistance Range
100 ⦠through 5 Meg ⦠(linear taper).
Resistance Tolerance
Standard: ±20%
Special: Other tolerances available in most
resistance values.
Power Rating, Watts
1/4 watt per section through 100K
1/5 watt per section above 100K
Full rating @ 55°C derated to no load at 85°C,
linear taper, bushing mounted control on steel panel
4" x 4" x .050" (101.6mm x 101.6mm x 1.27mm).
(Derating required on two section controls.)
Voltage Rating
Bushings to Terminals:
High pot test, one minute â 750 VAC
Operating maximum
â 500 VDC
Across End Terminals:
350 VDC, load not to exceed listed wattage ratings.
Resistance Tapers
Standard: Linear, 10% Audio and 10% CCW Audio
Special tapers available to meet most requirements
Angle of Rotation
Total Rotation
Without Switch: 300° ± 5°
With Switch: 315° ± 5°
Effective Rotation
Without Switch: 300° (approximate)
With Switch: 290° (approximate)
Panel Mounting Information
Bushing Mount
Standard: Brass
(continued on next page)
Technical Data Sheet 1448C
Technical Data Sheet 1270E
CTS CORPORATION / MANUFACTURER OF RELIABLE ELECTRONIC COMPONENTS
|
▷ |