|
118GA332R103B1 Datasheet, PDF (1/2 Pages) CTS Corporation – Commercial 3/4inch (19.1mm) Diameter, 2-Watt, Wirewound Variable Resisters | |||
|
®
Commercial 3/4"
(19.1mm) Diameter,
2-Watt, Wirewound
Variable Resisters
Features
⢠Fully enclosed construction
⢠Long rotation life
⢠Optional grounded or insulated rotor
construction
⢠Incorporated fixed resistor available
⢠Available with nylon shaft
⢠Bushing mounting style
⢠RoHS compliant
Series 118
Electrical and Mechanical Specifications
Resistance Range
1 ohm through 20,000 ohms (linear taper)
Resistance Tolerance
Standard: ±20%
Special: ±10%
Power Rating, Watts
2 watts @ 55°C derated to no load @ 105°C,
linear taper, bushing mounted control on
steel panel 4"x4" x .050"
(101.6mm x 101.6mm x 1.27mm).
Voltage Rating
Terminals to mounting surface (insulated types only):
High pot test, one minute â 900 VAC
Operating Maximum â 500 VDC
Across end terminals:
Determined by resistance value and
wattage rating
Resistance Tapers
Standard: Linear
Taps Available
None
Incorporated Fixed Resistor
A fixed resistor can be incorporated at the end
of CW or CCW rotation to a minimum of 15% of
the total resistance value. The rotation is
shortened by an amount proportional to the ratio
of the fixed resistor to the total resistance value.
Angle of Rotation
Total Rotation: 270° ± 5°
Rotational Torque
Turning Torque: 1/2 to 10 in-oz. (36-720 gf-cm)
Stop Strength
4 in-oz. (4.61 Kgf-cm)
1-2
CTS Electronic Components
© 2006 CTS Corporation. All rights reserved. Information subject to change.
9/30/06
www.ctscorp.com
|
▷ |