CS-DM-MJB Datasheet, PDF (2/2 Pages) CRYSTEK CORPORATION – 2.4mm Plug, Solder Clamp for IW1501 Cable

MICROWAVE
A Division of Crystek Corporation
Step 1 ^{1.1 Trim Cable as shown.}
Step 2
2.1 Install O-ring onto clamp nut where shown and slide clamp nut over cable in orientation
shown.
2.2 Insert cable into solder ferrule until dielectric and foil are flush with solder ferrule face and
solder cable braids where shown.
2.3 Slide dielectric stop over cable center conductor and solder contact flush to stop to
dimension shown.
NOTE: Distance from end of cable center
conductor to Ref. Pl. is 0.270 (Ref)
3.1 Insert cable/contact sub-assembly into connector until seated and tighten clamp nut to
Step 3
25-35 in-lbs.
Product Control:
Crystek Part Number:
Revision Level:
CS-DM-MJB
A
CRYSTEK
CORPORATION
Release Date: 04-Jan-11
Responsible: K. Piotrowicz
Page 2 of 2
12730 Commonwealth Drive • Fort Myers, Florida 33913
Phone: [phone] • 800-237-3061
Fax: [phone] • www.crystek.com