IB0512LT-1W Datasheet, PDF (3/3 Pages) Crystek Corporation – 1W, FIXED INPUT, ISOLATED & REGULATED SINGLE OUTPUT SMD DC-DC CONVERTER

OUTLINE DIMENSIONS & PIN CONNECTIONS
MECHANICAL DIMENSIONS
5.75 [0.226]
( Side V ie w )
6.00 [0.236]
RECOMMENDED FOOTPRINT
17.78 [0.700]
15.24 [0.600]
14 13 12 10 9 8
( To p View )
12 3
56 7
0.60 [0.024]
12.22 [0.481]
2.54 [0.100]
A
0.25 [0.010]
A
5 max
Note:
Unit: mm[inch]
1.30 [0.051]
Pin section tolerances: 0.10mm[ 0.004inch]
General tolerances: 0.25mm[ 0.010inch]
TUBE OUTLINE DIMENSIONS
21.20 [0.835]
14.00 [0.551]
14 13 12 10 9 8
1 23
5 67
2.54 [0.100]
2.10 [0.083]
2.54 [0.100]
1.00 [0.039]
FOOTPRINT DETAILS
Pin
Fu nc t i on
1
GND
2
Vin
6
0V
7
+ Vo
Others
NC
N C:No Connection
REEL PACKING OUTLINE DIMENSIONS
Taping dimension:
4.00 [0.157]
∅1.50[0.059]
18.00[0.709]
∅1.50[0.059]
2.00 [0.079]
1.75 [0.069]
14.20[0.559]
0.50[0.020]
7.10 [0.280]
0.60 [0.024]
8.60 [0.339]
7.30 [0.287]
Note:
Unit: mm[inch]
General tolerances: 0.5mm[ 0.020inch]
L=530mm[20.866inch] Devices per tube quantity: 28pcs
L=220mm[8.661inch] Devices per tube quantity: 10pcs
Taping reel dimension:
24.00[0.945]
6.80[0.268]
37.40 [1.472]
∅100.00 [3.937]
∅13.00 [0.512]
Note:
∅21.50 [0.846]
Unit: mm[inch]
General tolerances: 0.5mm[ 0.020inch]
Devices per reel quantity: 400pcs
Note:
1. Operation under minimum load will not damage the converter; However, they may not meet all specification listed, and that will reduce the life
of product.
2. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
3. Only typical models listed, other models may be different, please contact our technical person for more details.
4. In this datasheet, all the test methods of indications are based on corporate standards.
The copyright and authority for the interpretation of the products are reserved by MORNSUN
Specifications subject to change without notice.
IB_LT-1W
B/1-2010
Page 3 of 3